Introduction
Thank you for choosing this AEG product. It is designed to provide impeccable performance for many years with innovative technologies that simplify daily life. Please read this manual to get the very best from your appliance.
Visit our website for:
- Usage advice, brochures, troubleshooting, service, and repair information: www.aeg.com/support ? [website]
- Product registration for better service: www.registeraeg.com ? [register]
- Accessories, consumables, and original spare parts: www.aeg.com/shop ? [shop]
Customer Care and Service
Always use original spare parts. When contacting an Authorised Service Centre, please have the following data available: Model, PNC, and Serial Number, which can be found on the rating plate.
Symbols used:
- ⚠️ Warning / Caution - Safety information
- ℹ️ General information and tips
- ? Environmental information
Content is subject to change without notice.
1. Safety Information and Installation
WARNING! Refer to the separate Installation Instructions booklet for detailed Safety Information and Installation. Read the Safety chapters carefully before any use or maintenance of the appliance.
2. Product Description
2.1 Control Panel Overview
A line drawing of a telescopic cooker hood is shown. The control panel is depicted with buttons.
| Function | Description | |
|---|---|---|
| 1 | First Speed | The fan switches to first speed level. |
| 2 | Second Speed | The fan switches to second speed level. |
| 3 | Third Speed | The fan switches to third speed level. |
| 4 | Lamp | Turns the lights on and off. |
3. Daily Use
3.1 Using the Hood
Check the recommended speed according to the table below:
| Speed Setting | Recommended Use |
|---|---|
| 0/1 | While heating up food, cooking with covered pots. |
| 2 | While cooking with covered pots on multiple cooking zones or burners, gentle frying. |
| 3 | While boiling and frying big quantities of food without a lid, cooking on multiple cooking zones or burners. |
It is recommended to leave the hood operating for approximately 15 minutes after cooking.
To operate the hood:
- Pull out the drawer of the hood more than 5 cm. The control panel is exposed.
- To activate the function, press the [0/1 button].
- If needed, change the speed by pressing the desired button [speed 1], [speed 2], or [speed 3].
The hood's light works independently of other hood functions. To illuminate the cooking surface, press the [light button]. Closing the drawer has no effect on the hood light.
The hood remembers the last fan speed setting when the drawer is closed. The hood will operate on this fan speed level when the drawer is pulled out again.
To turn off the fan, press the [0/1 button] or close the hood drawer.
4. Care and Cleaning
4.1 Notes on Cleaning
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth, warm water, and a mild detergent. After cooking, some parts of the appliance can get hot. To avoid stains, allow the appliance to cool down and dry with a clean cloth or paper towels. Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior and grease filters carefully to remove fat. Fat accumulation or other residue may cause fire.
Grease filters can be washed in a dishwasher. The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, but this has no influence on the appliance's performance.
Charcoal Filter: The saturation time of the charcoal filter varies depending on the type of cooking and the regularity of grease filter cleaning. The activated charcoal filter is not washable and cannot be regenerated. It must be replaced approximately every 4-6 months of operation, or more frequently for particularly heavy usage.
4.2 Cleaning the Grease Filter
Filters are mounted with clips and pins on the opposite side.
To clean the filter:
- Press the handle of the mounting clip on the filter panel underneath the hood (1).
- Slightly tilt the front of the filter downwards (2), then pull. Repeat these steps for all filters.
- Clean the filters using a sponge with non-abrasive detergents or in a dishwasher.
- To mount the filters back, follow the first two steps in reverse order. Repeat for all filters if applicable.
Note: The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, but this has no influence on the appliance's performance.
4.3 Replacing the Charcoal Filter
WARNING! The charcoal filter is NON-washable! The filter cannot be regenerated!
To replace the charcoal filter:
- Remove the grease filters from the appliance. Refer to "Cleaning the grease filter" in this chapter.
- Turn the filter counterclockwise (1) and then pull (2).
- Mount the filters back following the steps in reverse order.
In any case, it is necessary to replace the filters at least every four months.
4.4 Replacing the Lamp
This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can only be replaced by a technician. In case of any malfunction, refer to "Service" in the "Safety Instructions" chapter.
5. Environmental Concerns
Recycle materials with the ♻️ [recycling symbol] symbol. Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the ♻️ [recycling symbol] symbol with household waste. Return the product to your local recycling facility or contact your municipal office.
Welcome to AEG
Welcome to AEG
