User Guide for atomi models including: AT1705, AT1705 55W Wireless Charging Station, 55W Wireless Charging Station, Wireless Charging Station, Charging Station, Station
Guangdong Fenergy Technology Co., Ltd AT1705 55W Wireless Charging Station 2BDF9-AT1705 2BDF9AT1705 at1705
55W Wireless Charging Station 55W Wireless Chargeing Station 55 Wireless Chargeing Station 55W Wireless Chargeing Station Sp ecif icat io n s Model AT1705 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - - Reorient or relocate the receiving antenna. - - Increase the separation between the equipment and receiver. - - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - - Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. Radiation Exposure Statement The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.Adobe PDF library 10.01 Adobe Illustrator CS6 (Windows)