Hikvision - Leading the future of AIoT
User Manual for HIKVISION models including: CB140PT Conduit Base
2018−2020 Hikvision USA Inc. • All Rights Reserved • Specifications subject to change without notice. 030620NA ▽. CB140PT. Conduit Base. • Aluminum ...
Hikvision USA Inc., 18639 Railroad Street, City of Industry, CA 91748, USA • Hikvision Canada, 4848 rue Levy, St-Laurent, Quebec, Canada, H4R 2P1
File Info : application/pdf, 2 Pages, 329.02KB
DocumentDocumentCB140PT Conduit Base · Aluminum Alloy Material with Surface Spray Treatment · Waterproof Design · Bracket Cable Hole for Simple Cable Fitting The bracket should be installed on a flat wall. The wall must be capable of supporting a minimum of three times the total weight of the camera and mount. The maximum load capacity of the bracket is 9.92 lbs (4.5 kg). Available Model: CB140PT NOTE: See special installation instructions for select cameras on next page. Specifications Appearance Material Dimensions Weight CB140PT Hikvision white Aluminum alloy Ø5.39" x 2.03" (Ø137 mm x 51.5 mm) 1.16 lbs (527 g) Hikvision USA Inc., 18639 Railroad Street, City of Industry, CA 91748, USA · Hikvision Canada, 4848 rue Levy, St-Laurent, Quebec, Canada, H4R 2P1 Tel: +1-909-895-0400 · Toll Free in USA: +1-866-200-6690 · E-Mail: sales.usa@hikvision.com · www.hikvision.com © 2018-2020 Hikvision USA Inc. · All Rights Reserved · Specifications subject to change without notice. 030620NA Dimensions Special Installation Instructions for Select Cameras Some cameras require the following steps to install a CB140PT. 1. Twist to remove trim ring from camera mounting base. 2. Loosen the pressure clamp locking screw on the mounting base. 3. Slide pressure clamp away from mounting base. 4. Detach mounting base from camera. 5. Position mounting base on the CB140PT. 6. Align four screw holes on the mounting base to the four inner screw hole posts on the CB140PT. 7. Attach mounting base to the CB140PT with four screws. 8. Restore the assembly: 1) Re-position the pressure clamp. 2) Re-tighten the pressure clamp lock screw. 3) Place camera body on mounting base. 4) Re-attach and secure the trim ring. Do not use the three outer screw holes on the CB140PT rim; you must use the four inner screw hole posts. Figure 1, Attaching CB140PT to a Select Camera Model (Typical) Hikvision USA Inc., 18639 Railroad Street, City of Industry, CA 91748, USA · Hikvision Canada, 4848 rue Levy, St-Laurent, Quebec, Canada, H4R 2P1 Tel: +1-909-895-0400 · Toll Free in USA: +1-866-200-6690 · E-Mail: sales.usa@hikvision.com · www.hikvision.com © 2018-2020 Hikvision USA Inc. · All Rights Reserved · Specifications subject to change without notice. 030620NA