Package Contents
- ARGB Control & USB Module (1 pc)
Installation
Follow these steps to install the ARGB Control & USB Module into your PC case.
- Prepare your PC case.
- Remove the fan tray from the case if necessary.
- Mount the ARGB Control & USB Module into the designated area within the PC case.
- Secure the module using the original screws provided with your case.
- Connect the necessary cables to the module.
- Route the I/O cables from the bottom of the case to the module.
Important Note: Use original screws for installation.
Cable Connection Guide
Connect the module to your motherboard and power supply unit (PSU) as follows:
- To Motherboard USB 3.0 Header: Connect the USB 3.0 cable from the module to the motherboard's USB 3.0 header. Ensure correct orientation (+5V, D, GND).
- To PSU: Connect the power cable from the module to your PSU.
- To Motherboard Fan Header: Connect the fan header cable from the module to the appropriate fan header on your motherboard.
- General Motherboard Connection: Connect the module to the motherboard as indicated.
Warning: Do not connect the wrong type of LED connector. Connecting to a 12V connector will cause permanent damage. ⚠️
I/O Ports Function
| Function | Action | Note |
|---|---|---|
| Fan Blade Lighting Effect Mode | Press KEY_1 | |
| Fan Blade Lighting Effect Color | Press KEY_3 | |
| Fan Rim Lighting Effect Mode | Press KEY_2 | |
| Fan Rim Lighting Effect Color | Press KEY_4 | |
| MB Sync | Press KEY_1 or KEY_2 for 3 seconds | Blink white color 3 times and pass control to motherboard |
| Quit MB Sync | Press KEY_1 or KEY_2 once | Light effect reverts back to rainbow when disable combination |
| Combine Fan Blades + Rim | Press KEY_1 + KEY_2 together for 3 seconds | * Key_2 & Key_4 are NOT functional at combination. Combination Lighting Effect Mode: Press Key_1. Combination Lighting Effect Color: Press Key_3. |
| Remove Combination | Press again KEY_1 + KEY_2 together for 3 seconds | Light effect reverts back to rainbow when disable combination |
Lighting Effects
Control lighting effects and colors using the buttons:
Lighting Effect Modes:
- Rainbow
- Static
- Cycle
- Warning
- Breathing
- Morph
- Taichi
- Color Cycle
Lighting Effect Colors:
- Purple
- Light Blue
- Yellow
- White
- Red
- Green
- Blue
Special modes available when combining fan blades and rim effects: Volume, Meteor.
