Owner's Manual for DOMUS models including: 19809 ALPHA-SM Exterior Ceiling Mounted Light, 19809 ALPHA-SM, Exterior Ceiling Mounted Light, Ceiling Mounted Light, Mounted Light
DOMUS ALPHA-SM EXTERIOR CEILING MOUNTED LIGHT » Lights For You
File Info : application/pdf, 1 Pages, 273.22KB
DocumentDocument29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia Phone: 02 9554 9600 | Fax: 02 9554 9433 enquiries@domuslighting.com.au | www.domuslighting.com.au Installation Manual ALPHA-SM Date:09/2019 Variants Item No. Blk Alu Wht Colour Temp 19809 19413 19812 ALPHA-SM-WW 3000K Warm White 19810 19414 19813 ALPHA-SM-W 5000K White 19808 19415 19811 ALPHA-SM Body Only (No Lamp) Description: Square body exterior surface mounted ceiling light Thank you for purchasing your new LED ALPHA-SM Wall Light, Please take the time to read and understand the instruction sheet below. Failure to do so may void warranty. Specifications Voltage: 240V AC Power: 6W IP Rating: 65 CRI: 80 Lumen (±5%): Beam Angle: CCT: Warm White 3000K (450lm) Dimmable: Yes White 5000K (500lm) 60° 3000K - 5000K Operating Temp: -20o - 65o Lifespan: 40,000hrs Steps: · Please make a visual inspection to the fixture prior to installation. If any defect is to be found please return to you place of purchase for a replacement. · Make sure all power is correctly turned off from the mains and NOT just from the switch. · Unscrew the lamp cover from the main body. Carefully insert the supplied lamp ensuring the pins line up before securing into place. · Ensure the silicon gasket is in place. Please do not over tighten as this may damage the gasket and inhibit correct IP protection. · Once lamp has been installed please remove the base mounting plate. Carefully unscrew the three (3) stainless steel grub screws. · Mount mounting base plate using supplied screws. Please note that due to different mounting sub straights additional fixing screws maybe needed (Not supplied). · Proceed in connecting the power cable to the supplied terminal block. Due to the nature of this fixture the Earth wire MUST be connected. Please ensure the grommet supplied on the rear base plate is still present (removing this will prevent correct IP protection and void warranty) · Once connections are made please proceed in re-attaching the main body to the mounting plate. Turn mains power back on from the mains and test to make sure all is working. · To keep the finish maintained and in good appearance the manufacture recommends cleaning the fixture once every 12mnths with clean fresh water and a mild soap. Please rinse well. Wallmate Mounting Plate Terminal Block Mounting Plate Note: -The lamp must be installed by professional electrician -Ensure the power supply is switched off before fitting this product -Do not touch the lamp when in use -Keep away from hot steam and corrosive gas