Philips TAS7505 Wireless Speaker

Safety Information

Important Safety Instructions

• Ensure power supply voltage matches unit voltage. Rating label is on the back of the unit, accessible by opening the net cover.
• The speaker shall not be exposed to dripping or splashing.
• Do not place any source of danger on the speaker (e.g., liquid-filled objects, lit candles).
• Ensure sufficient free space around the speaker for ventilation.
• Use the speaker safely in an environment with temperatures between 0°C and 45°C.
• Only use attachments and accessories specified by the manufacturer.

Battery Safety Precautions

• Danger of explosion if battery is replaced incorrectly. Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.
• Battery in extreme high or low temperatures during use, storage, or transportation, and low air pressure at high altitude can pose safety hazards.
• Do not replace a battery with an incorrect type that can defeat a safeguard (e.g., some lithium battery types).
• Disposing a battery into fire or a hot oven, or mechanically crushing or cutting a battery can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding, or an extremely low air pressure environment may result in an explosion or leakage of flammable liquid or gas.

Warning

• Never remove the casing of this speaker.
• Never lubricate any part of this speaker.
• Place this speaker on a flat, hard, and stable surface.
• Never place this speaker on other electrical equipment.
• Use this speaker only indoors. Keep this speaker away from water, moisture, and liquid-filled objects.
• Keep this speaker away from direct sunlight, naked flames, or heat.
• Risk of explosion if a battery is replaced by an incorrect type.

Notice

TP Vision Europe B.V. hereby declares that this speaker is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The Declaration of Conformity can be found at www.philips.com/support.

This speaker is designed and manufactured with high-quality materials and components, which can be recycled and reused.

When this [crossed-out wheeled bin symbol] is attached to a product, it means that the product is covered by the European Directive 2012/19/EU. Please be informed about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old products will help prevent potential negative consequences for the environment and human health.

Your speaker contains batteries covered by the European Directive 2013/56/EU, which cannot be disposed of with normal household waste. Please be informed about the local rules on separate collection of batteries because correct disposal will help prevent negative consequences for the environment and human health.

FCC Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and consider removing the no-collocation statement.

Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer), and polyethylene (bags and protective foam sheet).

Your speaker consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding disposal of packaging materials, exhausted batteries, and old equipment.

Specifications

General Information

Amplifier

Speakers

Bluetooth

Note: Design and specifications are subject to change without prior notice.