TOWILD ALC-01 User Manual

Product Description

The TOWILD ALC-01 is a wireless remote control designed for bike lights. It is fixed to the handlebars using an o-ring strap and contains a replaceable CR1632 button battery.

Pairing with the Remote Control

To pair the bike light with the remote control:

1. When the light is turned on, press and hold the light button for 3 seconds to enter the pairing state. The bike light will flash once, and the indicator light will turn red.
2. Press any key on the remote control to match the light.
3. When the bike light indicator light turns off, the match is successful.

Note: Pairing usually takes less than 5 seconds. If the match is not successful, ensure the remote control is working properly. A blue light display when pressing the remote control button indicates it is working; otherwise, replace the battery.

Button Functions

The remote control has three buttons with the following functions:

• Button 1 (Power Symbol): Long press for 0.5 seconds to switch between intelligent and manual modes.
• Button 2 (Mode Symbol): Click to switch alert/lighting modes (BR&CL series) or focus/flood modes (Dlite series).
• Button 3 (Lightning Bolt Symbol): Click to set the light to maximum brightness. Long press to hold this brightness, and release to return to the previous brightness setting.

Additional Button Functions:

• Button 1 (Power Symbol): Long press for 0.5s/0.8s to turn the light on/off (only in smart mode can it turn on). Click to adjust brightness.
• Button 3 (Lightning Bolt Symbol): One key to maximum brightness, long press to hold, release to return to the previous setting.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.