Digital Night Vision | SIONYXSubmit a ticket : SIONYXRegister Your Camera | SIONYX Night Vision Solutions
User Guide for SIONYX models including: C018900, 108550QG, C018900 Nightwave Digital Camera, C018900, Nightwave Digital Camera, Digital Camera, Camera
SIONYX Nightwave Digital Camera - White [C018800] | Essenbay Marine
File Info : application/pdf, 2 Pages, 12.69MB
DocumentDocumentQuick Start Guide Box Contents Read BEFORE Installation Determine the Best Install Location AF AT 1x Nightwave Digital 1x PoE Injector Cables & Connectors 1x Camera cable (10m) 1x Network ethernet cable (2m) 1x Power 2/16 cable (2m) 2x RJ45 terminal 1x Cable zip tie Tools, Screws, Fittings 1x 7/16-inch open end wrench 1x 3/16-inch hex key (large) 1x 2 mm hex key (small) 1x 3/32-inch screwdriver 1x #3 Phillips bit, 1/4-inch hex shank 1x Ethernet cable grommet 1x RJ45 DIY camera connector 4x #12 flat washer 4x #12 mounting screw 6x M3x0.5x10mm cover screw Flat, level mounting surface that won't weaken the boat's structure Minimize obstructions to camera's field of view Mounting Options Highest possible location More than 1m from any interference source (magnetic compass, radio, radar, generator, motor) A) B) A) Screw from under surface into base plate above, or B) through base plate onto surface. Install right-side-up or upside-down. Cable Routing Options A) B) Route cable through A) baseplate and surface, or B) exit from the edge of the device, across the surface. Ensure cable length and routing is adequate for installation location interference (radios, radar, generators, motors). Get More Information View Complete Installation Guide Continued on Flip Side Quick Start Guide (Cont.) Wiring Overview Diagram IMPORTANT Feed ethernet cable down through baseplate first, BEFORE routing cable to PoE injector. AF AT Do not try to feed cable up through baseplate. Mounting Options View Complete InstallationConGnecutinigdthee Parts Nightwave Digital is powered from the IP67 PoE injector IP67 PoE injector has CVhionorsaenagderilflrsoizme a9pVprDopCritaote3to6VthDe Cin,staanlldatiVonousutr4fa8cVe DmCaterial and types of fasteners Suggested power cable for the PoE injector is 16/2 AWG Duplex DC Wire Install the camera into its own breaker or a panel switch using a 2 Amp fuse Use a professional installer. If not possible, please be careful with cable routing and power Register Your Device Register your device and stay up to date by visiting the URL or scanning the QR Code below. www.sionyx.com/register Need Help? ONLINE CHAT www.sionyx.com SUBMIT A TICKET www.sionyx.com/contact 24/7 SUPPORT www.support.sionyx.com THIS IS SIONYX. We are committed to enhancing visibility, safety and performance in low-light environments, empowering professionals and adventurers with cutting-edge digital night vision technology.