Instruction Manual for Supereyes models including: M1, Mini Screen LCD Bubble Remover Machine, M1 Mini Screen LCD Bubble Remover Machine, LCD Bubble Remover Machine, Remover Machine, Machine
Купить автоклав M-Triangel M1-MAX для дисплеев с доставкой в Суперайс
File Info : application/pdf, 6 Pages, 558.28KB
DocumentDocumentM1 M1 Bubble Remover Machine Operating Instruction 1.--------------------------------1.Safety Rule 2.--------------------------------2.Specification 3.--------------------------------3.Features 4. ------------------------------4. Installation 5.--------------------------------5.Operation 6.--------------------------------6.Maintenance 1. 1.Safety Rule For your own safety, please read this manual carefully. Please familiar with the application and limitation of the machine, as well as the relevant potential risk. A. A.Please read this manual carefully before using the machine. B. B.Please keep the grounding good, bad grounding may result in equipment damage or endanger personal safety. C. C.It is strictly forbidden to open the electric box as nonprofessionals. 2. 2.Specification AC220V ( AC110V) VoltageAC220V (AC110V Optional) 20-30 Working Environment20-30CleanDust-free Heating Mode: Constant temperature heating 350*180*88 Equipment size 350*180*88mm 350*280mm7 Platform size350*280mm7 inch 6.58KG 6.82KG Equipment weight:Net weight6.58KG Gross weight6.82KG 300W Equipment Power300W 2 It is recommended that use a vacuum pump who not less than 2 liters 3. 3.Features 1.7 1. 7inch small size, ultra-thin in addition to foam machine, powerful. 2.30 2. High efficient , 30 seconds per piece 3 . 3. High intelligent equipment, one button automatic operation 4. 4.Operation is extremely simple bubble remove machine 4. 4. Installation 1. Plug inand put the vacuum pump triangle plug into the triangle port while put the vacuum tube into the under port. 2. 2. Install the muffler on the air compressor (1) 1Press the top red button is turned off, up is start up. (2) 2The right side is open valve, vertical is pumping, sideways is deflated. 5. 5.Operation 1. 2.1.Check setting on the screen 4030 Laminating temperature: 40; Vacuum time: 30s; Laminating time: 30s; Defoaming temperature: 40. * .*Attention: This is factory settings, please don't adjust it by yourself. 2. 2.Put the screen into the door, the cable on the bottom 3.30 3.3. Press the start button, about 30 seconds, you can press the stop button, take out the screen. Attention: Press the screen after turn the cable 6. Maintenance Items Platform and platen Life of machine Notes Keep clean, no clutter inside. For keep it long use, turn off the power when not in use.