Safetrust SABRE IoT Sensor Quick Start Guide

Specifications

Wiring

Parts List

IoT Reader

• Mullion / Mini Mullion
• Screws (SMF #6-32x3/8" SS) - 1 casing to back plate mounting screw
• Junction
• Nylon anchor plug - 4 Nos

Wall Mount / Keypad

• 4 Nos - Back Plate mounting screws for Wall
• Screws (SMF #6-32x3/8" SS) - 1 casing to back plate mounting screw
• Junction
• Nylon anchor plug - 4 Nos

Installation and Configuration

Mullion & Mini Mullion

1. Wiring: Connect IoT Sensor per the wiring diagram above. Select corresponding wiring for Wiegand or OSDP output. Optional electronic relay output for signaling.

2. Mounting and Testing: Once the IoT Sensor has been wired to the controller lines, it's time to mount the reader. (A) Once the reader mounting plate is secured in place or Mullion reader mounted to the wall, it's time to place the cover and secure with a screw at the bottom. (B) Finally, power the reader and test with a card to make sure the reader was wired correctly and powered. (C) If wired correctly, the beeper will sound and LEDs flash.

Wall Mount & Keypad

3. Open Safetrust Wallet App: Open the Safetrust Wallet APP and select the 'Admin Installer' tab. Ensure your system admin has assigned you this role.

4. Configure Reader: With the Admin Installer tab open, bring your phone in range of the IoT Sensor. Once visible in the App, highlight and select "Configure".

5. Reader Settings: Select the corresponding IDENTITY SYSTEM from the drop-down box. Assign a short "Name" and "Description" using alphanumeric characters. Enable the slider for "Self Enrollment" if you intend to allow users to enroll mobile credentials using their existing legacy cards from this reader. Click 'Save' to successfully complete reader configuration.

6. Confirmation: When the IoT Sensor information is successfully saved to the Credential Manager and assigned to the Identity System, the new description will appear in the Admin Installer with a unique serial number assigned.

7. Accessing with Mobile Device: To open the door, simply present your mobile device running the Safetrust Wallet application to the IoT Sensor reader. When the phone is within the configured activation range, the LED within the assigned credential for this identity system will be green. If "Auto Authenticate" is enabled for the mobile credential, the credential will be sent to the IoT Sensor reader whenever the mobile device is within the activation zone.

8. Device Settings: To adjust settings like "Sensitivity Level to Activate" (determines how easily your mobile device picks up the activation zone) and "Anti Passback" (defines the number of seconds between each attempt to resend a mobile credential), select the 'Settings' tab from the left navigation panel. Options include Passcode/Biometric Enable, Passcode Timeout, and Leashing Mode.

Compliance Information

FCC Compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.

RF Exposure: Mobile RF exposure device; minimum separation of 20 cm between the device and any users or installers is required.

Canada Radio Certification: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation.

Model: SA520

FCC ID: 2ANI5SA520

IC ID: 23133-SA520

SN: 1000000

Manufacturer: Safetrust Inc.

Contact: +1 510 9 SAFE 09, sales@Safetrust.com

Made in: USA