Instruction Manual for REMARK models including: 2022, 2022 WRX Dual Catback, WRX Dual Catback, Dual Catback, Catback
RK-C2076S-03 & RK-C2076S-03T, SUBARU 2022 WRX R1-Spec Dual catback | REMARK USA
File Info : application/pdf, 1 Pages, 231.88KB
DocumentDocumentMANUFACTURER: YEAR: MODEL: TRIM: CHASSIS CODE: REMARK PART #: PRODUCT INFORMATION SUBARU 2022+ WRX VB RK-C2076S-03 : R1 SPEC. DUAL CATBACK, STAINLESS STEEL RK-C2076S-03T : R1 SPEC. DUAL CATBACK, BURNT STAINLESS STEEL No. Description P 1 3" Composite 2-Bolt Gasket A 2 3" Metal 2-Bolt Gasket R 3 2.5" Metal 2-Bolt Gasket T 4 M10 Serrated Hex Head Bolt L=35mm S 5 M10 Serrated Nut 6 M8 Serrated Hex Head Bolt L=35 L 7 M8 Serrated Nut I A Front Midpipe Section S B Rear "T" Midpipe Section T C Driver's Side Muffler Canister D Passenger's Side Muffler Canister Part Num. Qty 76C2-T03 1 76C2-02 1 65C2-S01 2 M10B35 6 M10N 6 M8B35 2 M8N 2 N/A 1 N/A 1 N/A 1 N/A 1 Torque ~42 ft-lbs. ~42 ft-lbs. ~25 ft-lbs. ~25 ft-lbs. 1 3.1in / 78.2mm 5.4in / 136mm 2 4.0in / 101mm 3.0in / 76.2mm 3 3.7in / 93.3mm 2.6in / 65.5 mm 5.0in / 127mm 4.6in / 117.5mm D 3.4in / 86.5mm P A R 3+ 4 + 5 T S B L A Y 2+ 4 + 5 3+ 4 + 5 C O U T A 1+ 6 + 7 Front of Vehicle 1. We recommend installation to be performed by a trained and/ or qualified technician. I 2. Remove OE exhaust system: rear mufflers and midpipe. N 3. Remove OEM donut style gasket from downpipe (downpipe to midpipe connection). No adapter is needed. S 4. Install REMARK exhaust components using the original rubber hangers unless otherwise noted. T A L L 5. Install all gaskets and hardware. Leave the hardware hand tight. 6. Align flanges, gasket, and snug all hardware so that sections cannot move. 7. Check positioning of the exhaust piping, and tips(s). Reposition if needed by loosening hardware, adjust position and retighten hardware. 8. When placement is confirmed, tighten all hardware to recommend torque spec. A 9. Gently shake/ move the exhaust system to ensure there is proper clearance around the entire system, especially T the tips to bumper. I 10. Throughly wipe down the exhaust system from any grease, dirt, handprints, fingerprints, etc... as these may cause O a permanent stain once the exhaust reaches operating temp. NOTE: If optioned with the Burnt finish tips, make N sure to only clean with car wash soap and water. Some cleaners may affect the Burnt finish. 11. Start the engine 12. Check for any leaks, fitment issues, rubbing, etc.. 13. Re-check for exhaust leaks, fitment issues, and re-torque all hardware after ~100 miles of driving. 1-year limited manufacturer defect warranty from date of purchase W All warranty claims are subject to inspection by REMARK at our facility Limited Warranty only applies to the original purchaser of the product A REMARK is not responsible for fitment issues on non-US spec vehicles as all products are developed on US spec R models R Product finishes are not covered under warranty and considered wear & tear A No warranty whatsoever will be valid if the defect was caused by abuse, negligence and/or mishandling. That N includes weather conditions, natural disasters, any road/off-road conditions, and any accidents/collision you were T part of. Y Acidic cleaning products or steel wool are not to be used unless by a trained professional. Some chemical cleaning products may damage the product and/or finishes. P Wear and tear (the damage that happens to our product in ordinary use) is not covered by our limited warranty. O Improper installation or misuse of the product may lead to failure and damage to both product and vehicle. The L I C user assumes all responsibility. All products are intended for use off-public streets and highways. Vehicle manufacturer warranty may be voided should any modification(s) or removal(s) of OEM(factory) components are determined. Federal and state law may prohibit the removal, modification or rendering of any device affecting vehicle emis- Y sions or state regulated decibel limits. It is the customer's responsibility to be aware of federal, state and local laws. User assumes all cost and risks associated with purchase and installation of aftermarket components. REMARK is not responsible for any fees, fines, or any type of penalties you have received from any authority. Buyers are responsible for all return shipping fees unless otherwise noted REMARK does not cover any installation, un-installation, labor fees, or related REMARK, INC. 16782 HALE AVE, STE A, IRVINE CA 92606 SALES@REMARK-USA.COM 949.366.7661