Installation Guide for peepers models including: WF440 Peepers 36pc Retail Therapy Peepers 32pc Counter, WF440, Peepers 36pc Retail Therapy Peepers 32pc Counter, 36pc Retail Therapy Peepers 32pc Counter, Retail Therapy Peepers 32pc Counter, Therapy Peepers 32pc Counter, Peepers 32pc Counter, 32pc Counter

WF440 Peepers 36pc instructions-111121 1a

RDPC\Rendering (RDPC)

Retail Therapy – Peepers Wholesale

PDF preview unavailable. Download the PDF instead.

Peepers GC32 Display Instructions ?v=1640027174
Peepers 32pc Counter

1. Attach the base to the display with the 1/4"-20 x 2.25" bolts.

2. Attach the mirrors to the display. TURN PAGE FOR DETAILS.

3. Attach the POS 1/2" below the

6

mirror. Peel off

3pc

protective

coating. TURN

PAGE FOR DETAILS.

4. Insert accessory hooks into the rail.

5. Using the #6 x

1/2" pan head

screws, attach the

case holder to the

5pc

top of the display.

6. Starting from the bottom insert a 5pc nose piece into the display panel, then a 3pc above. Repeat until all nose pieces are on the display. TURN PAGE FOR DETAILS.

5 1

2 3
4

If you experience any problems please call A. Pepper Designs at 412-434-8344 REF: Peepers 36pc counter display

1/4"-20 x 2.25" pan head (X2)

PARTS LIST

#6 x 1/2" pan head sheet metal screw (X4)

POS holder (X2)

5pc Nose piece (4)

Case Holder
Double sided tape (X6)
3

Hooks (X2)
1/2"

Mirror (X2)

3pc Nose piece (4)

2 If double sided tape is not attached already put a piece on the back of each mirror in this location.

Attach mirrors (x2) to the side rails. First put the #6 x 5/8" silver screw through the mirror hole and screw it into the rail until screw catches. Next remove double sided tape on the back of mirror while screw is still not tighten down. Now align mirror so it is vertically straight. Press mirror onto the rail and finishing tightening screws, do not over tighten screws!!!

6
If double sided tape is not attached already, put one piece on the top and bottom of each POS card.
Attach the POS holders to the rails. Start by aligning the POS holders to the center of the rail 1/2" below mirror. Remove adhesive backing and firmly stick to rail, repeat on other side.

Insert nose pieces starting from the bottom
To remove:
Pull the top of nose piece toward you, then pull entire nose piece up. There is a locking devise to prevent it from coming out.
SIDE VIEW


Adobe PDF library 15.00