Instruction Manual for Veise models including: 801 Door Handle Lever, 801, Door Handle Lever, Handle Lever, Lever
Veise Fingerprint Door Lock with 2 Lever Handles - Keyless Entry Door Lock, Keypad Door Lock with Handle, Electronic Deadbolt Front Door Lock Set, Auto Lock, Easy Installation, Matte Black
RZ02B Technical documentation
Thank you for purchasing our products. Please review this manual thoroughly before operating your device. All pictures in this manual are for illustration purpose only. Actual product may vary due to product upgrade. Mounting Screw (D) Rear Lever (E) Latch(A) Strike(C) Latch & Strike screws (B) Front Lever (F) Parts list A Latch x1 B Latch & Strike screws x4 C Strike x1 D Mounting Screw x2 H Hand Tool x1 E Rear Lever x1 F Front Lever x1 TOOL REQUIRED: Do not use an electric screwdriver during installation. 2-3/8" or 2-3/4" (60 or 70mm) 1. Prepare the door and check dimensions If your door already has the holes shown in the picture below, proceed to the next step, if your door does not have holes, use the mounting template to drill a new hole. 2-1/8" (54mm) 1" (25mm) Door thickness: 1-3/8" to 2" (35mm or 50mm) 1" 25mm 2. Latch backset adjustment Backset is the distance from the door edge to the center of the hole in the door. The latch is provided with adjustable design which can fit either 2-3/8''(60mm) or 2-3/4''(70mm) backset. A. If the backset of your door is 2-3/8"(60mm), no need to adjust the latch. B. If the backset of your door is 2-3/4"(70mm), please adjust the latch. 2-3/8" (60mm) 2-3/4" (70mm) 3. Install latch and strike IMPORTANT: The latch should be aligned with the chiseled properly. IMPORTANT: Make sure the hole in door frame is drilled a minimum of 1" (25mm) deep. 4. Reverse lever direction (Optional) IMPORTANT: The front lever is installed for right-handed door in default. If your door is left-handed, please exchange the front and rear lever with each other. WARM REMINDER: While you exchange the lever direction, the edge of inner mechanism may be a little sharp, please protect your hands from being hurt. ARear Lever disassembly steps 1. Find the joint point, press the point by using the Hand Tool. 2. Till the joint point is pressed down completely, then pull out the lever. Sometimes, it may happen that the joint point is unable to be pressed down completely, in this case, please press the joint point along with pulling out the lever. 1 Joint point 2 Pull out BFront Lever disassembly steps 1. Rotate the lever and find the joint point of the lever through the hole on the housing. 2. Press the joint point with the Hand Tool, till the joint point is pressed down completely, then pull out the lever. Sometimes, it may happen that the joint point is unable to be pressed down completely, in this case, please press the joint point along with pulling out the lever. CExchange the lever Exchange the lever of front and rear with each other, press the lever back till you hear a mild "Ding" sound. 1 2 3 Pull out Align the hole with the inside joint point 5. Install front and rear lever The base of spindle must be rotated aligning to the hole. 6. Test the Lever Keep the door open, checking out front and rear lever to test if it works smoothly.Adobe PDF library 15.00