SkyRC - Official Website
Instruction Manual for SKYRC models including: MPS010, 600155, MPS010 Magnetic Switch, MPS010, Magnetic Switch, Switch
15 часов назад — 1x MPS010 Switch Unit. 1x Activation Magnet. 1x User Manual. 1x Location Sticker. Effortlessly activate your RC model with a simple tap of a magnet. Securely ...
15 hours ago —
File Info : application/pdf, 6 Pages, 517.82KB
DocumentDocumentv. 17 Instruction Manual MPS010 Meet SkyRC Magnetic Switch Effortlessly activate your RC model with a simple tap of a magnet. Securely integrated into your setup, it delivers seamless control and intuitive operation, eliminating the hassle of traditional switches. Swipe and go: power with a magical tap! Contents of the Box 1x MPS010 Switch Unit 1x Activation Magnet 1x User Manual 1x Location Sticker - 2 - Specifications Item Input Voltage Standby Current Continuous Output Current Peak Output Current Magnetic Sensing Range LED Indicator Power-On State Descriptions DC 3-13V 5uA (when output is off) 3.5mA (when output is on) 7A 10A 1.01.5cm above the LED indicator Green ON: active Green OFF: inactive 10 seconds: Previous state is restored >10 seconds: The switch enters a random state - 3 - Warning A short circuit or reversed supply polarity may damage the switch. Keep the switch away from strong currents, electric motors, and electromagnets. Ensure thorough testing of the installation before use. Improper use or incorrect connections will void any after-sales service. Installation 1. Connect the switch to the battery and the device. Secure the switch inside the fuselage using silicone or foam, and apply the location sticker to indicate the activation area. Avoid Interference: Keep the switch away from other magnets, such as canopy magnets or brushless motors, to ensure proper operation. Operating Instructions 1. Activating the Switch Place the magnet directly above the sensing area (1.01.5cm above the LED) to turn on the switch. The green LED will light up to indicate that power is being supplied to the output. - 4 - 2. Deactivating the Switch To turn off the switch, pass the magnet again above the sensing area. The green LED will turn off, indicating that the power supply is disconnected. 3. State Retention After Power Loss If power is interrupted and restored within 10 seconds, the switch will resume its previous state. If the power is interrupted for more than 10 seconds, the switch's state (on/off) will be random upon restoration. Troubleshooting Issue Green LED doesn't light up The switch does not activate/ deactivate Possible Cause Solution Power is not connected or the input voltage is incorrect Check power connections and ensure the voltage is DC 3-13V The magnet is not placed correctly Ensure the magnet is within the 1.01.5cm range above the LED The Switch does not retain its state after power loss Power interruption was longer than 10 seconds Ensure power interruptions are minimized; the switch will reset after 10 seconds of power loss - 5 - The manual is subject to change without notice; please refer to our website for the latest version! Manufactured by SKYRC TECHNOLOGY CO., LTD. Floors 4, 5, & 8, Building 4, Meitai Technology Park, Guanguang South Road, Guanlan, Longhua District, Shenzhen 518110, China 2025.01 www.skyrc.com