User Manual for AOC models including: AS110DX Ergonomic Monitor Arm, AS110DX, Ergonomic Monitor Arm, Monitor Arm
AS110DX
File Info : application/pdf, 2 Pages, 7.50MB
DocumentDocumentAS110DX AS110DX/86 Ergonomic Monitor Arm User Manual A. Clamp-Mounting B. Hole-Mounting C. Cable-Management D. VESA Mount Installation E. Monitor Angle Adjustment Packaging List M4x12MM C M5x12MM MAX 10~90 mm Note: Please freely adjust the clamp distance based on the thickness of your desk. Step 2 B. Hole-Mounting Procedure Step E Insert screws from (E) into (H) plate, tighten the 3 screws (D) onto the arm base. H Warning: Please make sure to tighten the screws. D H Step 2 G Hop on (G) into the bottom twister (E) E according to the thickness of table. Monitor Size: 13"~32" Weight Capacity: 2~9 kg VESA Size: 75x75 mm, 100x100 mm A. Clamp-Mounting Procedures Step L-Plate C =+ Turner Warning Please tighten the 3 black screws (D) onto the base. D H Warning: Please make sure to tighten the screws. Diagram of full-assembled monitor arm specs in depth +60°/ -45° Warning: Please make sure to tighten the screws. Diagram of full-assembled monitor arm specs in depth +60°/ -45° 320 mm 320 mm 10~90 mm Clamp-Mounting 10~90 mm Hole-Mounting C. Cable Management Pull out upper compartment Tighten screws Unscrew bottom compartment D. VESA Mount Installation Step 1 Step 2 E. Adjust Monitor Angles +60° -45° Manually tighten A or B onto the top 2 holes, then hook on the monitor. Please do not fully tighten until monitor is stable. Warning: Please make sure to tighten the screws. Monitor Weight Adjustment "+" Increase weight capacity "" Decrease weight capacity Once monitor is stable, screw to tighten top 2 and screw bottom 2 as well. AFTER INSTALLATION, ADJUST GAS-SPRING POWER Warning 1. Ensure monitor is tightened to monitor arm 2. Ensure monitor is not over-weight (2~9kg) Weight Adjustment Reduce Arm Weight Capacity Increase Arm Weight Capacity Warning Note: Please ensure monitor is within the 2~9kg weight range. Condition 1: After attached, your monitor is freely movable in any direction without adjustment. Condition 2: After attached, monitor will bounce up, please use the wrench provided to turn "-" counterclockwise until stable. Condition 3: After attached, monitor will fall down, please use the wrench provided to turn "+" clockwise until stable. Envision Peripherals Inc. 490 North McCarthy Blvd. Suite #120 Milpitas, CA 95035 AOC International (Europe) B.V. Prins Bernhardplein 200, 1097 JB Amsterdam, The Netherlands www.aoc.com Made in China Q&A 1) Why monitor arm is hard to press down? It is normal to feel pressure while pressing down without a monitor. Once the monitor is mounted, the weight of itself helps to reduce the airpressure, then the arm will be easy to press down. 2) Why my monitor cannot move lower or higher freely? Please adjust the "+" or "-" for best experience. Please do check your monitor weight, if > 9kg, arm will not hold. 3) Why my Type-C does not charge? Each Type-C cable has different materials and please reverse the cable to try again.