CREATE Warm Towel Mini - User Manual

Introduction

Thank you for choosing the CREATE Warm Towel Mini electric towel rack. Before using the appliance, please read these instructions carefully for correct usage.

The safety precautions included will reduce the risk of death, injury, and electrical shock if strictly followed. Keep this manual in a safe place for future reference, along with the completed warranty card, original product packaging, and proof of purchase. If possible, pass these instructions on to the next owner of the appliance. Always follow basic safety precautions and accident prevention measures when using an electrical appliance. CREATE assumes no liability for customers failing to comply with these requirements.

Security Instructions

When using any electrical appliance, basic safety precautions should always be observed:

• Carefully read these instructions before using the appliance for the first time and keep them for future consultation.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
• Keep plastic bags and other packaging materials out of the reach of children. They can be dangerous.
• Do not plug in before making sure the voltage on the rating plate and that of your household are the same.
• Make sure the electric socket is adequately earthed.
• Do not place the appliance close to showers, bathtubs, pools, etc.
• Do not submerge the appliance in water or any other liquids.
• Do not let children play with the appliance. Keep the appliance out of the reach of children.
• Always use it with the elements in the upright position.
• The external parts of the appliance get hot during use; avoid touching them until the appliance cools down.
• Do not place the appliance under a socket.
• Do not place the appliance near inflammable objects or products.
• When you use it for the first time, leave the heater on for 2 or 3 hours at the maximum temperature setting in a ventilated place, in order to disperse the initial “new” smell.
• If this appliance is installed on a bathroom wall, it must always be in a place where no person in the shower or in the bath may touch it or switch it on.
• It is normal to hear some noises caused by the oil heating up or cooling.
• Do not use the thermal heater directly on the floor without attaching the legs.
• If the cable is damaged, it must be changed by an Authorised Service Centre.

Parts List

The following parts are included with the appliance:

1. Heating bars
2. Side supports
3. Temperature indicator
4. 1h heating time button
5. On/Off button
6. Wall brackets
7. Fixing screws
8. Wall plugs
9. Wall screws

Assembly Instructions

Before installation, check the following:

1. The control panel must be in the lower position during installation.
2. The distance between the bathtub and the appliance must be at least 60 cm.
3. The distance between the top of the house and the appliance must be at least 25 cm.
4. The distance between the floor and the appliance must be at least 80 cm.

Step 1: Mark on the wall the 4 holes to be made with the drill. The horizontal separation between the holes must be 450 mm and vertically 300 mm.

Step 2: Once the holes have been marked, drill the 4 holes of 8 mm diameter.

Step 3: Detach the wall brackets as shown in the image.

Step 4: Insert the plug into the wall hole, then attach the outer accessory to the wall brackets and use the wall screw to fix the accessory properly. Repeat the step for the rest of the holes.

Step 5: Fix the internal accessories and the 4 front accessories to the towel rack with the screws, then attach the decorative cover so that the screw is not visible.

Step 6: Once the accessories are attached to the towel rack, insert the internal accessories to the external ones on the wall, adjust the distance you want and fix the fixing screws so that it is well secured.

How to Use

1. Continual Heating Mode: When you press the power button, the appliance will be in Continual Heating mode, and will continue to heat until you turn it off.
2. Towel Warming Mode: Press the time button to start the timer, the screen will show the time 1 hour, continue pressing to choose the desired time as many times as you want until it reaches 8 hours. The LED display always shows the room temperature.

Cleaning

• Always switch off the power and let the appliance cool down before cleaning.
• Use a soft cloth to carefully wipe the glass surface.
• Do not use an abrasive material to wipe it, to avoid damaging the glass surface.

Environmental Information

In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in electric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled, treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal of the product by the user involves application of the administrative sanctions according to the laws.