Deuba Automatic Compressed Air Hose Reel

Intended Use

The automatic compressed air hose reel is equipped with a retractable compressed air hose. It is suitable for connection to a compressed air source or a compressed air tool. This product is intended for domestic use only. The manufacturer assumes no liability for damages resulting from non-intended use. Any modification to the product can negatively affect safety, cause danger, and will void the warranty.

General Information & Safety Warnings

This product is only suitable for domestic use and not for commercial use.

ATTENTION! Observe the safety and assembly instructions to avoid the risk of injury or damage to the product.

Important: Read these instructions carefully and thoroughly. Keep these instructions for future reference. If you pass the product on to someone else, ensure you also pass on this manual.

Keep small parts out of the reach of children. Pay special attention when unpacking; keep plastic bags and other packaging materials away from children to prevent suffocation.

Check all elements and parts for completeness and damage. Later claims cannot be accepted. Despite careful checks, damage during transport can occur. Do not assemble the product if parts are damaged, as defective parts can cause hazards and health damage.

Never modify the product. Modifications will void the warranty and can make the product unsafe or dangerous.

For cleaning, use a sponge and warm soapy water. Do not use solvent-based cleaners or detergents, as bleach can damage the product.

Safety Instructions

• Do not use the product if it is damaged.
• Do not modify the product.
• Do not attempt to repair the product yourself. Contact Deuba customer service immediately for questions or defects.
• Disconnect the hose reel from the air supply before making adjustments, changing accessories, or performing maintenance.
• Never lay the air hose over sharp edges.
• Check the hose for damage before each use.
• Keep the product away from heat and fire.
• Do not aim the compressed air at yourself or other persons during operation.
• Turn off and disconnect the air supply, and depressurize the product when it is not in use.
• Always retract the compressed air hose fully into the reel when not in use.
• Never disconnect the inlet hose from the air supply by pulling on the hose itself.
• Keep children and unauthorized persons away from the work area.
• Always wear a dust mask, safety goggles, and non-slip safety shoes when operating the hose reel.
• Never allow children to use the product.
• Do not use the product when tired or under the influence of drugs, alcohol, or medication.
• Do not wear loose clothing or jewelry.
• Never connect the inlet hose to an air source whose pressure exceeds 12 bar (approx. 174 psi).
• Never use oxygen, carbon dioxide, combustible gases, or any bottled gas as an air source for this product.
• Never connect the product to the air supply before installation.

Operation

1. Connect the inlet hose to the air supply and the outlet hose to a compressed air tool.
2. Grip the ball stopper and pull the hose out.
3. To lock the hose, pull it out and stop at your desired locking position. There are 2-3 locking positions per meter of hose.
4. To unlock the hose, pull it out again and allow it to retract slightly. The hose will then retract automatically until the ball stopper hits the housing.
5. Always turn off and disconnect the air supply, and depressurize the hose before allowing it to retract. It is best to let the hose retract by itself.
6. The hose may sometimes fail to retract automatically after being fully extended. In this case, hold and pull the hose at the yellow warning mark (visible when the hose is fully extended) until the hose begins to retract.

Maintenance and Care

• Ensure that the pressure in the compressed air hose is fully released before maintenance or inspection.
• Clean the hose and the main housing with a damp cloth.
• Do not spray water or other liquids into the reel.
• Have the reel repaired only by a specialist.
• Check all parts for signs of wear. If defects are found, do not continue to use the product.
• Have parts replaced only with original spare parts by a specialist, in accordance with the manufacturer's specifications.
• Lack of care and maintenance can damage the unit and lead to dangerous situations. Regular maintenance contributes to product safety and increases its lifespan.
• Store the reel in a dry and cool place, out of reach of children.

Disposal

At the end of your item's long service life, please dispose of the valuable raw materials properly to ensure correct recycling. If you are unsure how to proceed, local disposal or recycling centers can provide assistance.

Parts List

Diagram illustrating the parts list: Component A is the Air hose reel. Component B consists of Expansion bolts (2x). A quantity of 1x is indicated for the reel.

Technical Data

Installation

Diagram showing the installation process: Illustrates selecting a location, marking drill points on a wall, drilling holes, and attaching the mounting bracket with expansion bolts.

1. Choose a location that is free of electrical wiring or other obstructions, and ensure that the mounting surface is sturdy enough to support the hose reel.
2. Position the mounting bracket against the surface where it is to be fixed. Mark the hole locations for screwing the expansion bolts onto this surface. It is advised to mount the hose reel at least 1 m from the floor.
3. Drill holes at the marked locations, ensuring they match the expansion bolts. The holes should be 51 mm deep with a diameter of 11 mm.
4. Fix the mounting bracket to the wall using the provided expansion bolts.
5. Check that the hose extends and retracts smoothly.