TRIXIE Pet Carrier Assembly Instructions
Model: #39343
Parts List
| Part | Description | Quantity |
|---|---|---|
| 1 | Right Side Panel: Rectangular panel with corner connectors. | 1x |
| 2 | Left Side Panel: Rectangular panel with corner connectors. | 1x |
| 3 | Door: Grated panel with a handle. | 1x |
| 4 | Base Panel: Rectangular panel with slots for assembly. | 1x |
| 5 | Top Panel: Rectangular panel. | 1x |
| 6 | Back Panel: Rectangular panel. | 1x |
| 7 | Fitted Mat: Soft rectangular mat. | 1x |
| 8 | Front Panel: Rectangular panel with slots for assembly. | 1x |
| 9 | Vertical Rods: Long, thin cylindrical rods for upright support. | 2x |
| 10 | Top Front Rods: Shorter, thin cylindrical rods. | 2x |
| 11 | Bottom Front Rods: Shorter, thin cylindrical rods. | 2x |
| 12 | Top Back Rods: Shorter, thin cylindrical rods. | 1x |
| 13 | Bottom Back Rods: Shorter, thin cylindrical rods. | 1x |
| 14 | Door Strut: Metal bar for door support. | 1x |
| A | Screws: Small fasteners for connecting parts. | 4x |
| B | Connectors/Caps: Round corner pieces used with screws. | 8x |
| C | Metal Pins: Cylindrical pins for securing the door. | 2x |
| D | Nuts: Hexagonal fasteners for metal pins. | 2x |
Assembly Instructions
- Step 1: Attach the top front rods (10), bottom front rods (11), top back rod (12), and bottom back rod (13) to the right side panel (1). Secure these rods using screws (A) and corner connectors (B). The diagram indicates specific angles for some rod placements.
- Step 2: Connect the partially assembled frame from Step 1 to another set of rods, forming a base structure.
- Step 3: Rotate the structure to orient it for the next steps.
- Step 4: Insert the two vertical rods (9) into the designated connectors on the base structure.
- Step 5: Slide the back panel (6) into the grooves provided by the vertical rods (9).
- Step 6: Slide the top panel (5) into the grooves of the vertical rods (9).
- Step 7: Slide the base panel (4) into the grooves of the vertical rods (9).
- Step 8: Attach the door strut (14) to the front vertical rods, positioning it for the door.
- Step 9: Attach the front panel (8) to the structure. Secure it using metal pins (C) and nuts (D) through the pre-drilled holes.
- Step 10: Attach the left side panel (2) to the top and base panels. Secure it using screws (A) and corner connectors (B). If the panel is difficult to attach, loosen the pre-mounted screws on the corner connectors of this element.
- Step 11: Rotate the assembled structure to the upright position.
- Step 12: Insert the door (3) into the front opening of the carrier.
- Step 13: Secure the door (3) in place using the remaining metal pins (C) and nuts (D).
