iDatalink - Support • 1.866.427.2999
iDatalink - Home
Instructions for idatastart models including: HCA 320, HCA 384, HCX 192, HCX 512, HCA 320 Add On Security Kit, HCA 320, Add On Security Kit, Security Kit, Kit
File Info : application/pdf, 7 Pages, 829.92KB
DocumentDocumentPRODUCT GUIDE
ADS-SEC
DOCUMENT NUMBER REVISION DATE 20241104
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
TERMS OF USE
Automotive Data Solutions Inc. ("ADS") products are strictly intended for installation by Certified Technicians who are employed by a registered business specialized in the installation of automotive aftermarket electronics products. Prior to beginning installation of an ADS product in a vehicle, it is the Certified Technician's responsibility to review the most current Product Guide, Install Guide and vehicle-specific notes available in Weblink®. ADS is not responsible for any damages whatsoever, including but not limited to any consequential damages, incidental damages, damages for loss of time, loss of earnings, loss of profit, commercial loss, loss of economic opportunity and the like that may or may not have resulted from the use, misuse, improper installation or operation of its products. ADS reserves itself the right to suspend any Weblink® account without notice and decline to offer technical support to non-Certified Technicians, noncompliant Certified Technicians or end users.
www.idatalink.com
WELCOME
Congratulations on the purchase of your ADS-SEC add-on security kit for iDataStart HC series remote starters. This kit includes a multi-tone siren, a security LED, and a digital multi sensor featuring shock, tilt, and glass break detection.
You are now a few simple steps away from enjoying your new remote starter unit's security kit with enhanced features.
Before starting your installation, please ensure that your ADS-SEC security kit is programmed with the correct firmware and that you carefully review the install guide.
GETTING STARTED - 1 OF 1
TABLE OF CONTENTS
ADS-SEC Product Guide Security Kit Layout Wiring Diagrams Type 1 - Wiring Diagram : ADS-SEC with HCA(320) OR HCA(384) Type 2 - Wiring Diagram : ADS-SEC with HCX(192) Type 3 - Wiring Diagram : ADS-SEC with HCX(512) Starter Kill - Wiring Diagram
PAGE 2 OF 7 · 20241104
3 4 5 6 7
NEED HELP?
1 866 427-2999
support@idatalink.com
idatalink.com/support www.12voltdata.com/forum www.facebook.com/groups/idatatech
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
ADS-SEC
Scan QR code for setup and install video
ADS-SEC Product Guide www.idatalink.com
ADS-SEC SECURITY KIT
BOX CONTENTS
· DIGITAL MULTI SENSOR (SEC-DMS) · SECURITY LED (SEC-LED) · SIREN (SEC-SIR) · SIREN ADAPTER (SEC-SIR-ADP) · HARNESSES:
· DMS ADAPTER CABLE (GREEN TO BROWN 4 PIN) · SIREN ADAPTER (3 PIN BLACK) · DMS DATA CABLE (BLACK TO BROWN 4 PIN) · HARDWARE BAG 1: · (4) SELF TAPPING SCREWS · (2) ZIP TIES · (1) SIREN MOUNTING BRACKET · HARDWARE BAG 2: · (4) LOOSE WIRES · (1) EMPTY BLACK 12 PIN CONNECTOR HOUSING
SHOCK SENSITIVITY DIAL
DIGITAL MULTI SENSOR (SEC-DMS)
SECURITY KIT LAYOUT - 1 OF 1
LED MICROPHONE
2 PIN BROWN GROUND (-)
2 PIN WHITE
4 PIN GRAY - TELEMATIC PORT
SIREN ADAPTER (SEC-SIR-ADP)
2 PIN WHITE - ALARM LED 2 PIN BROWN - SIREN
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
USB-C PORT 4 PIN BLACK - RS PORT
4 PIN BLACK 4 PIN GREEN
3A MINI FUSE 3 PIN BLACK - RS PORT
3 PIN BLACK SINGLE WIRES
12 PIN BLACK
ADS-SEC
SIREN (SEC-SIR)
SECURITY LED (SEC-LED) DMS DATA CABLE
DMS ADAPTER CABLE SIREN ADAPTER CABLE
4 LOOSE WIRES EMPTY CONNECTOR HOUSING
PAGE 3 OF 7 · 20241104
SIREN
SIREN MOUNTING BRACKET (SHOWN ATTACHED) LED 4 PIN BROWN 4 PIN BROWN
ADS-SEC Product Guide www.idatalink.com
ADS-SEC WITH HCA(320) OR HCA(384)
STEP 1
PROGRAM AND CONFIGURE THE HCA(320) OR HCA(384) REMOTE STARTER IN WEBLINK:
· ENABLE ALARM FEATURES. 1 · SELECT AND CONFIGURE THE PROGRAMMABLE OUTPUTS
(POCS) SHOWN BELOW OR USE ANY AVAILABLE POC. ADD PINS USING THE SUPPLIED WIRES IF NECESSARY. CONFIGURE THE POCS FOR SIREN AND LED TO USE WITH THE SIREN ADAPTER (SEC-SIR-ADP).
HCA(320) OR HCA(384) REMOTE STARTER
APPLIES TO HCA(320) OR HCA(384) HARDWARE ONLY. SEE THE REMOTE STARTER'S LABEL:
DE00000000
HCA(320) 1.0
2 2021-10-30
MADE IN CHINA
SP-1
DE00000000
HCA(384) 1.0
2 2021-10-30
MADE IN CHINA
SP-1
TYPE 1 - WIRING DIAGRAM - 1 OF 1
STEP 2
PROGRAM AND CONFIGURE THE DIGITAL MULTI SENSOR (SEC-DMS) FOR "DATA" IN WEBLINK
DIGITAL MULTI SENSOR (SEC-DMS)
STEP 4
IF ALSO INSTALLING A COMPATIBLE TELEMATIC DEVICE, CONNECT TO THE DMS AS SHOWN.
STEP 5
ADJUST DMS SHOCK SENSITIVITY USING THE ON-BOARD DIAL (DEFAULT).
PAGE 4 OF 7 · 20241104
STEP 3
CONNECT ALL ALARM COMPONENTS AS SHOWN.
SECURITY LED (SEC-LED)
SIREN ADAPTER (SEC-SIR-ADP)
SIREN (SEC-SIR)
DMS DATA CABLE
INSERT PROVIDED LOOSE WIRES INTO
THE BLACK 12 PIN CONNECTOR (M2) IF NEEDED.
M2 01
02
03
21
04
43
05
M2 6 5 87
06 07
10 9
08 WHITE/PURPLE·BLACK DOT - LED (-)
1
12 11
09
10 WHITE/BLACK·BLACK DOT - SIREN (-)
1
11
12
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
+ADS-SEC
GROUND (-)
LED (-) INPUT - YELLOW/BLUE SIREN (-) INPUT - YELLOW/BROWN
12V (+) INPUT - RED
SIREN ADAPTER CABLE
ADS-SEC Product Guide www.idatalink.com
ADS-SEC WITH HCX(192)
STEP 1
PROGRAM AND CONFIGURE THE HCX(192) REMOTE STARTER IN WEBLINK:
· ENABLE ALARM FEATURES. 1 · SELECT AND CONFIGURE THE PROGRAMMABLE OUTPUTS
(POCS) SHOWN BELOW OR USE ANY AVAILABLE POC. ADD PINS USING THE SUPPLIED WIRES IF NECESSARY. CONFIGURE THE POCS FOR SIREN AND LED TO USE WITH THE SIREN ADAPTER (SEC-SIR-ADP).
HCX(192) REMOTE STARTER
TYPE 2 - WIRING DIAGRAM - 1 OF 1
STEP 2
PROGRAM AND CONFIGURE THE DIGITAL MULTI SENSOR (SEC-DMS) FOR "ANALOG OUTPUT" IN WEBLINK
DIGITAL MULTI SENSOR (SEC-DMS)
PAGE 5 OF 7 · 20241104
STEP 3
CONNECT ALL ALARM COMPONENTS AS SHOWN.
SECURITY LED (SEC-LED)
SIREN ADAPTER (SEC-SIR-ADP)
APPLIES TO THE HCX(192) HARDWARE ONLY. SEE THE REMOTE STARTER'S LABEL:
DE00000000
HCX(192) 1.0
2 2021-10-30
MADE IN CHINA
SP-1
INSERT PROVIDED LOOSE WIRES INTO
THE BLACK 12 PIN CONNECTOR (M2) IF NEEDED.
M2 01
02
03
21
04
43
05
M2 6 5 87
06 07
10 9
08 WHITE/PURPLE·BLACK DOT - LED (-)
1
12 11
09
10 WHITE/BLACK·BLACK DOT - SIREN (-)
1
11 BROWN/BLACK·BLACK DOT - STARTER KILL (-)
12
21 43 M3 6 5 87
10 9
M3 01 02 03 04 05 06 07 08 09 10 TAN·SILVER DOT - ALARM (-)
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
SIREN (SEC-SIR)
STEP 4
ADJUST DMS SHOCK SENSITIVITY USING THE ON-BOARD DIAL (DEFAULT).
GROUND (-)
DMS DATA CABLE
DMS ADAPTER CABLE
OPTIONAL
1A TO STARTER KILL RELAY
WARN AWAY (-) OUTPUT - GREEN (NOT USED) FULL ALARM (-) OUTPUT - BLUE GROUND (-) INPUT - BROWN 12V (+) INPUT - RED
+-
LED (-) INPUT - YELLOW/BLUE SIREN (-) INPUT - YELLOW/BROWN
12V (+) INPUT - RED +-
ADS-SEC
SIREN ADAPTER CABLE
ADS-SEC Product Guide www.idatalink.com
ADS-SEC WITH HCX(512)
STEP 1
PROGRAM AND CONFIGURE THE HCX(512) REMOTE STARTER IN WEBLINK. ENABLE ALARM FEATURES.
HCX(512) REMOTE STARTER
TYPE 3 - WIRING DIAGRAM - 1 OF 1
STEP 2
PROGRAM AND CONFIGURE THE DIGITAL MULTI SENSOR (SEC-DMS) FOR "DATA" IN WEBLINK
DIGITAL MULTI SENSOR (SEC-DMS)
PAGE 6 OF 7 · 20241104
STEP 3
CONNECT ALL ALARM COMPONENTS AS SHOWN.
SECURITY LED (SEC-LED)
APPLIES TO HCX(512) HARDWARE ONLY. SEE THE REMOTE STARTER'S LABEL:
DE00000000
HCX(512) 1.0
2 2021-10-30
MADE IN CHINA
SP-1
DMS DATA CABLE
STEP 4
ADJUST DMS SHOCK SENSITIVITY USING THE ON-BOARD DIAL (DEFAULT).
SIREN (SEC-SIR)
GROUND (-)
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
ADS-SEC
ADS-SEC Product Guide www.idatalink.com
STARTER KILL - NORMALLY CLOSED
NOTE
THE BASIC STARTER KILL RELAY DIAGRAM SHOWN BELOW BREAKS CONTINUITY OF THE WIRE FROM THE IGNITION SWITCH TO THE STARTER MOTOR WHEN THE ALARM IS ARMED AND THE IGNITION IS TURNED ON. THE DEFAULT STARTER KILL POC (BROWN/BLACK·BLACK DOT) IS SHOWN, BUT ANY AVAILABLE POC CAN BE CONFIGURED FOR STARTER KILL.
STARTER KILL - WIRING DIAGRAM - 1 OF 1
PAGE 7 OF 7 · 20241104
INSERT PROVIDED LOOSE WIRES INTO
THE BLACK 12 PIN CONNECTOR (M2) IF NEEDED.
M2 01
02
03
21
04
43
05
M2 6 5 87
06 07
10 9
08
12 11
09
10
11 BROWN/BLACK·BLACK DOT - STARTER KILL (-)
12
RELAY SOLD SEPARATELY
87 85 87A 86
30
IGNITION (+)
TO STARTER MOTOR
FROM VEHICLE IGNITION SWTICH
Patent No. US 8,856,780 CA 2759622 Automotive Data Solutions Inc. © 2024
ADS-SEC
ADS-SEC Product Guide www.idatalink.com