User Manual for microSHIFT models including: SH003-002 Trail Trigger Shifter, SH003-002, Trail Trigger Shifter
ADVENT X Trail Trigger Pro Shifter 1x10 Single Click | microSHIFT
File Info : application/pdf, 14 Pages, 690.20KB
DocumentDocumentTrail Trigger Shifter User Manual TRAIL TRIGGER © 2021 microSHIFT | AD-II Engineering Inc. SH003-002 www.microSHIFT.com REMINDER Before installing the products, please read and understand the installation procedures. Improper installation can lead to premature product failures or even injuries. If you have any questions on how to install, please contact us or consult with a professional bicycle mechanic. 1 Tools and Supplies 3 Shifter Positioning Procedures 4 Setup the Cockpit 4 Proper Shifter Position 5 Horizontal Positioning 7 Rotational Positioning 8 Tightening the Shifter 9 Shift Cable Installation Procedures 10 Cable Routing 10 Proper Housing Length 12 2 1. Torque wrench 2. 4mm Hex bit 3. Allen wrenches 3 Start by standing over the bike on flat ground. Install the brake levers, the shifter, and the grip with clamps loosened. Adjust the brake levers to your preference. 4 Part I Put your hand in your normal riding position. With your index finger on the brake lever, test out the shifter position of both the upper shift lever and lower shift lever with your thumb. You should be able to reach both levers easily without losing your grip. Repeat step 3 & 4 until the setup is comfortable. 5 Part II Proper setup of the Trail Trigger shifter is very individual. These instructions will give you a good starting point, but you may need to fine-tune the position after actual riding. 6 354.21° To position the shifter horizontally, move the shifter left and right along the handlebar. You can place the shifter on the inside or the outside of the brake lever. Repeat the adjustment until the setup is comfortable (Step 2). INSIDE OUTSIDE 7 Rotate the shifter around the handlebar. A good starting point is to rotate until the upper shift lever is 0-30 degrees from vertical. Repeat the adjustment until the setup is comfortable (Step 2). 0-30° 8 Tighten the clamp bolt to 5 Nm using a 4mm hex wrench. 5 Nm 9 Part I Before routing the cable, press the upper shift lever to shift all the way to the highest gear. Remove the cable cap. 10 Part II Route the cable into the cable port above the upper trigger and out through the barrel adjuster. 11 For best shifting performance, avoid sharp bends in the housing and make sure the housing is long enough to freely rotate the handlebar back and forth. For detailed instructions on cable routing, consult instructions from your frame manufacturer. 12 www.microSHIFT.com International service-tw@microSHIFT.com North America service@microSHIFT.com