Anko 3-in-1 Mop and Bucket Set
An efficient and versatile cleaning solution for your home.
360° Swivel Head Mop Technology
The mop features a 360° rotating head designed to reach difficult areas and corners with ease. This technology allows for effective cleaning in various settings such as kitchens, bathrooms, offices, and other surfaces, whether used wet for a deep clean or dry for dusting.
Mop Assembly
Follow these steps to assemble your mop:
- Insert the three plastic tongues on the mop head into the corresponding pad sleeves. Pull over the bottom of the mop head to the opposite side and insert the other set of tongues.
- Press the grey tabs back into place to secure the pad.
- Insert the stainless steel mop pole into the mop head.
- Screw the middle mop pieces onto the bottom rod attachment (two pieces).
- Screw the top soft grip handle onto the top middle mop piece.
- Congratulations! Your mop is now assembled.
Patented Three-Chamber Separation Technology
This innovative bucket design separates dirty water from clean water, ensuring you always clean with the cleanest floor. It features distinct compartments for clean water, mop cleaning reservoir, and dirty water.
Cleaning Preparation
- Step 1: Push the two side buttons to open the lid. Add clean water and your preferred detergent into the clean water reservoir.
- Step 2: Insert the lid onto the bucket, ensuring the two grey release buttons are firmly locked into place.
- Step 3: Turn the white knob to add clean water into the middle reservoir for cleaning. It is recommended to fill this chamber about three-quarters full. Avoid overfilling to prevent oversaturation. Adjust water levels based on your floor type and cleaning needs.
- Step 4: Swivel the mop head to change its direction, ensuring both ends of the mop pad become saturated. Note: Initially, only half of the mop pad might appear saturated. This is normal, and the pad will become fully saturated after initial use.
- Step 5: Begin mopping. The 360° swivel head will assist in cleaning all tough areas.
Repeat Step 4 to clean and moisten the mop pad as needed.
Repeat Step 3 if the water in the middle reservoir starts to run low.
After Use: When finished, pull out the black plug at the bottom of the mop bucket to drain the dirty water. Open the lid to clean the entire bucket. Remove the mop pad and place it in the washer/dryer.
System Parts
The set includes the following components:
- Three-chamber bucket lid
- Three-chamber bucket
- Soft grip handle (top of mop pole)
- Detachable stainless steel rod (middle of mop pole)
- Detachable stainless steel rod (bottom of mop pole)
- Flat mop head
- Reusable microfiber mop pads (2)
- Optional extension piece
Mop Parts
The mop consists of:
- Soft grip handle (top of mop pole)
- Detachable stainless steel rod (2) (middle of mop pole)
- Detachable stainless steel rod (bottom of mop pole)
- Flat mop head
- Reusable microfiber mop pads (2)
