Introduction
This document outlines the essential steps and considerations for installing and maintaining the Sub-Zero Model 506 Under-Counter Ice Maker. It is designed to guide users through the process, ensuring proper setup and continued optimal performance of the appliance.
Key Installation Steps
- Pre-Installation Considerations: Ensure proper ventilation, temperature range, and protection from elements.
- Electrical Connection: Details required voltage, Hertz, phase, and amperage, emphasizing the need for a dedicated circuit and proper grounding.
- Water Connection: Specifies materials needed, including copper tubing and a saddle-type shut-off valve, and provides step-by-step instructions for tapping into the water supply.
- Drain Connection: Explains gravity drain requirements and options for using a condensate pump if a direct drain is not feasible.
- Unit Installation: Covers unpacking, leveling, securing the unit, and connecting water supply lines.
- Front Panel Changes: Instructions for customizing the appearance of the ice maker by changing front panels.
Maintenance and Operation
- Thermostat Calibrations: Guidance on adjusting thermostats for altitude.
- Water Deflector Installation: Information on installing a water deflector for specific operating environments.
- Starting Up the Unit: Initial cleaning and operational checks before regular use.
- Normal Consumer Maintenance: Procedures for periodic cleaning to prevent mineral scale build-up and ensure ice release.
- Cleaning Solutions: Instructions for preparing and using cleaning solutions, including warnings about specific acid types.
- Condenser Cleaning: Steps to clean the condenser for efficient operation.
Important Safety Information
Throughout the document, crucial safety warnings are highlighted, particularly concerning electrical hazards and the proper use of cleaning agents. Users are urged to follow all safety precautions to prevent injury or damage to the appliance.
