Crumar Mojo Classic
The Ultimate Tonewheel Organ Experience
Front Panel Controls
- 3 Knobs: Used for Volume, drive, reverb.
- Shift Button: Use this button in combination with rotary speed to enable/disable the internal rotary speaker simulation. Use this button in combination with the manual button of the lower section to enable/disable the pedal-to-lower feature. Use this button in combination with notes of the upper manual to select the transposition amount.
- Vibrato/Chorus Controls: Two buttons, one large knob, and 6 LEDs for selection of vibrato and chorus effect.
- Rotary Speaker Speed Button: Push this button to switch speeds between slow and fast. Push and hold to stop the rotation.
- Upper Manual Selection Buttons: 2 Buttons for drawbar presets. 1 Button for manual mode. Hold manual for cancel mode. In manual mode, press the «manual» button to activate the "hold" mode.
- Lower Manual Selection Buttons: 2 Buttons for drawbar presets. 1 Button for manual mode. Hold manual for cancel mode. In manual mode, press the «manual» button to activate the "hold" mode.
- 8 Knobs: Used for click, crosstalk, percussion volume, balance, distance, bass, middle, treble.
- Percussion Buttons: 4 buttons for on/off, soft/normal, fast/slow, harmonic.
LED Indicators
- LED indicator: Becomes lit when a transposition is active.
- LED indicator: Becomes lit when rotary speaker simulation is deactivated.
- LED indicator: Becomes lit when pedal-to-lower feature is active.
Rear Panel Connectivity and System
- Headphones: Standard 1/4-inch jack.
- Balanced Outputs: Audio left and right TRS balanced outputs.
- Swell Pedal Input: TRS Jack input - signal on ring from 10k to 50k linear pot.
- Sustain Pedal Input: Used for controlling rotary speaker speed or for sustaining notes.
- Halfmoon or Footswitch Input: TRS jack input and slide selector. Ensure the correct accessory is selected before operation. Leave to FS if not used.
- MIDI IN/OUT USB: Device type B USB port used to connect Mojo Classic to your computer for MIDI input and output connectivity.
- MIDI IN/OUT: Standard MIDI cables plugs.
- System USB Ports: USB-host ports - use them to connect USB class compliant MIDI controllers, USB flash drives. Max 300mA.
Power and System Information
- Power On/Off Button: Located on the rear panel.
- AC Main Plug: Accepts input from 100 to 240 VAC.
- System Details: Model: Mojo Classic, Manufacturer: CRUMAR, Handmade in Italy by V.M.CONNECTION, Serial Number: S.N. 2019001, Certifications: CE, FC.
Getting Started
- Connect the AC power cord.
- Connect the audio outputs to your mixer or amplifier.
- Power the Mojo Classic on.
- Start playing.
Download the full PDF manual at www.crumar.it/support.