ULINE S-6719 S-12703 Laptop System Suspension Box Kit

Step 1

Gently fold along the perforated sides and edges. Pull the long sides upward gently. Remove center piece.

Figure 1: Diagram shows a flat cardboard piece with perforations. Arrows indicate folding the sides upwards and then removing the central section to create a frame.

Step 2

Fold panels completely upright. Hold panels together when inserting into box.

Figure 2: Diagram shows the assembled frame from Step 1 being placed into a shipping box. Arrows indicate holding the frame panels together during insertion.

Step 3

Repeat steps 1-2 for second frame.

Step 4

Place frame (C) film side up and accessory pad (D) into the box.

Step 5

Place notebook computer (B) centered on film of frame (C).

Step 6

Place frame (A) film side down onto notebook computer (B).

NOTE: Computer must be compressed between film.

Figure 3: Diagram illustrates the layering process inside the shipping box. It shows the shipping box (D), the accessory pad (D), frame (C) with its film facing up, the notebook computer (B) placed on the film, and finally frame (A) with its film facing down on top of the computer. A note indicates the computer should be compressed between the films.