Universal Cartridge Module - Formlabs Compatible Product
ProtoART - Resellers
Instructions for ApplyLabWork models including: PT-SP001PK, Prototype Engineering Series Spring Pink Formlabs Printers Compatible, Spring Pink Formlabs Printers Compatible, Prototype Engineering Formlabs Printers, Formlabs Printers
Applylabwork MSLA Prototype Engineering - Spring Pink - FEPshop - 3D Printers & More
Prototype Engineering Series APPLYLABWORK PRINTING INSTRUCTIONS Form 2 & 3 series printers Laser Spring Pink (PT-SP001PK) Check: • Resin tank and optical path are clean
File Info : application/pdf, 1 Pages, 120.90KB
DocumentDocumentAPPLYLABWORK PRINTING INSTRUCTIONS Form 2 & 3 series printers Laser Spring Pink (PT-SP001PK) Check: · Resin tank and optical path are clean · Shake resin bottle well before use Open-Mode (Form2): Ensure the printer is idle 1. Tap printer icon on home screen 2. Select "Settings" menu 3. Select "Open Mode" function 4. swipe the bar on top right side to "On" * LT tank is required in Form2 printers Cartridege (Form2 & Form 3 series): Refill the resin to durable-v2 cartridge. Open air vent, turn cartridge upside down, drip dry through air vent for at least 5 mins to minimize cross contamination, refill, shake well for 2 minutes, insert and print. Alternative solution: North America , Other Regions PreForm Setting: Select Printer: Form2 or Form3 series Select Material: durable v2 Layer Thickness: 100µm * please avoid any large aspect-ratio geometry (e.g. thin wall or long rod) in the object to reducre failures. Washing: Wipe off excess resin on prints with paper towel, submerge into 95% IPA and place the container in ultrasonic bath, wash for 5 minutes. Replace by clean IPA and repeat ultrasonic washing for another 5 mintes (total 10 minutes). Blow off all excess IPA and set parts in a shaded airy place to dry at least 2 hours before curing. *Dried print will be tacky to touch Post-curing (Mandatory): Submerge the parts into glycerol/glycerin (CAS # 56-81-5) and start FormCure with 60 / 30 mins setting. Wash off glycerol in water and dry off with paper towel. *If prints don't sink completely into glycerol, add water (no more than half of volume) to adjust liquid density. **If prints are still tacky to touch after post-curing, rinse with acetone (CAS # 6764-1) for no more than 1 minute will significantly reduce tackiness. Storage: · Do NOT keep the resin in the tank more than one week. Pour out the resin and gently wipe the tank with paper towel and IPA. · Keep resin away from heat and light. · NOT accessible to children. Note: · Keep printing environment well ventilated. · Wear gloves when handling Spring resin and avoid direct contact. · Vibration of the parts during printing might cause resin splash onto printer 's cover. Use paper towel and IPA to clean immediately. · Form2 printers usually give better printing quality than Form 3 series using Spring resin. · Color of printed parts will gradually turn yellow if contiuously receive photon energy. · Spring resin is sensitive to resin tank quality. Please use a new tank to print if repetitive failure occur, even within Form 3 tank lifetime. · Spring resin should NOT use with food, drink, or on/in the human body unless specifically indicated. Prototype Engineering Series