Samson MediaOne M30 Powered Studio Monitors
Important Safety Information
CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN.
The lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance instructions in the literature accompanying the appliance.
WARNING: To reduce the risk of electric shock, do not expose this apparatus to rain or moisture. Do not remove the cover (or back) as there are no user-serviceable parts inside. Refer servicing to qualified service personnel.
FCC Notice:
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Disposal Information: Do not mix this product with general household waste. Utilize separate collection systems for used electronic products in accordance with legislation for proper treatment, recovery, and recycling. Private households in EU member states, Switzerland, and Norway may return used electronic products free of charge to designated collection facilities or retailers. For other countries, contact local authorities for correct disposal methods. This ensures that disposed products undergo necessary treatment, recovery, and recycling, preventing potential negative effects on the environment and human health.
General Safety Instructions:
- Read and keep these instructions.
- Heed all warnings and follow all instructions.
- Do not use this apparatus near water.
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install according to manufacturer's instructions.
- Do not install near heat sources.
- Do not defeat the safety purpose of the polarized or grounding type plug.
- Protect the power cord from being walked on or pinched.
- Only use attachments/accessories specified by the manufacturer.
- Use only with specified carts, stands, tripods, brackets, or tables. Use caution when moving combinations to avoid injury from tip-over.
- Unplug during lightning storms or when unused for long periods.
- Refer all servicing to qualified personnel.
- Do not expose the apparatus to dripping or splashing, and do not place objects filled with liquids on the apparatus.
- Match wide blade plug to wide slot and fully insert.
- Ensure good ventilation around the unit.
- The mains plug/appliance coupler is used as a disconnect device and shall remain readily operable.
- This equipment is a Class II or double insulated electrical appliance and does not require a safety connection to electrical earth.
- No naked flame sources, such as lighted candles, should be placed on the apparatus.
Introduction
Thank you for purchasing the MediaOne M30 Powered Studio Monitors from Samson. These monitors are ideal for recording studios, video production suites, gaming, and general music listening on your computer. They deliver powerful, full-range sound with a 3" copolymer woofer and a 3/4" silk dome tweeter, providing deep bass and extended highs in a compact size.
The MediaOne M30 system includes one powered monitor (right) and one passive monitor (left). Features include rear panel RCA inputs and a 1/8" (3.5 mm) Stereo / Sub output for system expansion. A front panel headphone jack mutes the speakers for private listening.
Please complete the enclosed registration card for online technical support and product updates. Keep records of your serial number, date of purchase, and dealer name for future reference. For questions or comments, contact Samson at support@samsontech.com. For servicing, obtain a Return Authorization (RA) number from www.samsontech.com/ra before shipping. Retain original packing materials for returns.
Features
- Ported, tuned enclosures for accurate desktop monitoring.
- 3" Copolymer woofers with butyl surrounds.
- 3/4" silk dome high-frequency driver in a custom-designed waveguide.
- Front panel volume control.
- Front panel stereo 1/8" (3.5mm) headphone jack that mutes speakers.
- Rear panel RCA inputs for -10 dBV line level input.
- 1/8" (3.5mm) stereo / sub output.
- Solid MDF (Medium Density Fiberboard) construction.
- Auto standby mode to reduce power consumption.
Quick Start
Connecting the MediaOne M30:**
- Connect the left and right speakers using the included two-conductor, 1/8" (3.5mm) speaker cable.
- Turn the MediaOne M30 Volume control counter-clockwise until it clicks to the minimum/off setting.
- Connect the MediaOne M30 to an AC power outlet using the included power cable.
- Connect the audio output from your audio source (e.g., computer, portable audio device) to the RCA inputs on the right-side speaker.
- Turn the Volume control clockwise until it clicks to turn the speakers on. The front panel Power Indicator will light white.
- Play music and slowly raise the MediaOne M30 volume to a comfortable listening level.
Powering Up/Down Rule: Always follow the "last on, first off" rule for powered speakers. When powering up, turn on your mixer and other gear first, then your MediaOne M30. When powering down, turn off your MediaOne M30 first, then your mixer and other gear.
Standby Mode: The MediaOne M30 enters Standby mode after 5 minutes of no signal to save power. The Power Indicator will turn off. The speakers will automatically wake up when a signal is present at the inputs.
Adding an Active Subwoofer
To extend the low-frequency response, you can add a powered subwoofer. Set the subwoofer level to match the main speakers. Place the subwoofer ideally between the two main speakers, as deep-bass frequencies are nondirectional.
To connect a subwoofer:
- Connect your audio source to the left and right RCA Inputs of the MediaOne M30.
- Connect the MediaOne M30 1/8" STEREO / SUB Output to the left and right line inputs of your active subwoofer.
- Play music and adjust the MediaOne M30 and subwoofer levels to your preference. The MediaOne M30 front panel Volume control affects the entire system's level.
MediaOne M30 Layout - Powered Speaker (right speaker)
- Tweeter: 1" silk dome tweeter set in a custom waveguide.
- Low Frequency Driver: 3" woofer with a polypropylene cone and butyl surround for extended low-frequency response.
- Power / VOLUME (active): Rotary knob to control output level. Turn clockwise to turn on; turn counter-clockwise until it clicks to turn off.
- Headphone Jack: 1/8" (3.5mm) stereo output jack. Monitors mute when headphones are connected.
- Power Indicator (active): White LED indicates the unit is powered on.
- AUDIO INPUT: Unbalanced, Stereo RCA input connectors (-10 dBV consumer level). Red is for right input, white is for left input.
- 1/8" STEREO / SUB OUT: 1/8" (3.5mm) jack outputs stereo full audio to external devices or an active subwoofer.
- Bass Boost Switch: Enhances low-frequency response.
MediaOne M30 Layout - Passive Speaker (left speaker)
- TO LEFT SPEAKER: 1/8" (3.5mm) jack for connecting the passive left-side extension speaker using the included cable.
- AC INLET: Connect the supplied power cable here.
- Bass Port: Tuned low-frequency bass port. Do not block.
- Speaker Connections: 1/8" (3.5mm) jack for connecting the passive left-side extension speaker using the included cable.
Positioning the Speakers
For the best stereo image, position the MediaOne M30 monitors vertically, with the tweeter and woofer symmetrically aligned. Avoid horizontal placement, which can cause sound offsets. Near-field monitoring is popular due to cost and setup simplicity. Correct placement minimizes room reflection effects, crucial in multi-use project studios.
Minimize reflective surfaces near the monitoring area (e.g., tabletops, glass, walls, console surfaces) to prevent comb filtering. Consider acoustic foam if needed.
Set up a "mix triangle": the distance between the left and right monitors should be equal to the distance from the listener to each monitor, forming an equilateral triangle (approximately 60 degrees).
Specifications
| Specification | Details |
|---|---|
| Low Frequency Speakers | 3" (76.2mm) woofer, polypropylene cone with butyl surround |
| High Frequency Speakers | 3/4" silk dome tweeter |
| Frequency response | 50 Hz - 20 kHz (-2 dB) |
| Amplifier Power Rating | 2 x 10 watts (RMS) |
| Distortion (T.H.D.) | <0.1% |
| Signal-To-Noise | 83dB |
| Inputs Connectors | RCA (rear panel) |
| Headphone | 1/8" (3.5mm) Stereo Output |
| Stereo / Sub Output | 1/8" (3.5mm) |
| Controls | Power / Volume Knob, Bass Boost Switch |
| Indicators | White (Power) |
| Enclosure | MDF with textured vinyl covering |
| Dimensions (LxWxH) | 5" x 6.5" x 7.48" (127 mm x 165 mm x 190 mm) |
| Weight | 7.29 lb (3.31 kg) |
Samson continually improves products; specifications and images are subject to change without notice.
