Lift Tech Marine GEN 2 Key Pad / Control Panel

Key Pad for Wireless Remote Motors Only:

When the motor is plugged in, the ready light will be a solid green. The blue light will continue to blink until a phone is paired with the unit. Once a phone is paired, the blue light will remain solid. Pressing any button on the key pad will cause the status light to blink red.

The key pad enters a sleep mode after a set period of inactivity. To exit sleep mode, simply press and release any button.

For any issues, unplug the unit from power for 2 minutes to reset it.

Key Pad for Autostop Motors Only: (Unit will display 'Autostop')

Upon plugging in the motor, the ready light should blink green, unless the Autostop feature has already been configured. The blue light will blink until a phone is paired. After successful pairing, the blue light will stay solid. Pressing any button on the key pad will make the status light blink red. The green ready light will remain solid when both Autostop limits are set. For instructions on setting limits for an Autostop motor, please consult the Autostop instruction guide.

The key pad will automatically enter sleep mode after a period of inactivity. To wake it up, press and release any button.

If you encounter any problems, unplug the unit from power for 2 minutes to perform a reset.

Locking and Unlocking the Key Pad (Functionality is consistent across all motors):

To lock the key pad, press and hold the lock/unlock button for 10-15 seconds until both the ready and status lights begin blinking simultaneously. To unlock, press and hold the button again until the ready and status lights stop blinking. When the key pad is locked, the lights will blink for a short duration and then cease. Remote controls will be inoperable while the key pad is locked, but Bluetooth connectivity will remain active.

A blinking status and ready light upon pressing any button indicates that the key pad is locked. The blue light blinks if no phone is paired; it will be solid once a phone is paired.