DC1600 DC1602 Pair Instruction

Transmitter Types

The document illustrates two types of transmitters: a 1-channel transmitter and a 15-channel transmitter.

1-channel transmitter: Features UP, STOP, and DOWN buttons.

15-channel transmitter: Features UP, STOP, and DOWN buttons, along with a P2 Setting Button.

Technical Parameters

• Input: 5V
• Frequency: 433.92 MHz
• Distance: 60 meters outside and 30 meters inside
• Temperature: -20° ~ 55°
• Output Speed: 22~44 r/min (refer to nameplate)
• Running Limit: unlimited
• Waterproof Grade: IP20

1. Match up

Press and hold the Program button on the motor head for 2 seconds. The motor will jog and send out a long noise.

Press P2 twice on the 15-channel transmitter. The motor buzzes twice (interval of twice pressing should be not less than 0.5 second).

Press the UP button on the 1-channel transmitter. The motor jogs and sends out noise.

Press the UP button on the 15-channel transmitter. The motor jogs and sends out noise.

Result: OK

2. Change direction

Press P2 twice on the 15-channel transmitter. The motor buzzes twice (interval of twice pressing should be not less than 0.5 second).

Press the DOWN button on the 1-channel transmitter. The motor jogs and sends out noise for 6 times.

Press the DOWN button on the 15-channel transmitter. The motor jogs and sends out noise for 6 times.

3. UP and DOWN limit setting

Setting the UP limit:

Press the UP button on the transmitter. The motor jogs and sends out noise.

Setting the DOWN limit:

Press the DOWN button on the transmitter. The motor jogs and sends out noise.

Setting the third limit (UP):

Press the UP button, let the blinds reach the desired limit position, then press the STOP button and hold for 3 seconds.

Setting the third limit (DOWN):

Press the DOWN button, let the blinds reach the desired limit position, then press the STOP button and hold for 3 seconds.

4. Delete UP and DOWN limits

Press P2 button on the transmitter. The motor jogs and sends out noise.

Press DOWN button, let the blinds reach another desired limit position.

Press P2 button again. The motor jogs and sends out noise.

Result: OK

5. A third limit setting up

Press the UP button, let the blinds reach the desired limit position, then press the STOP button and hold for 3 seconds.

6. Delete the third limit

Press and hold the STOP button for 3 seconds. The blinds stop at the third limit position.

Press P2 button. The motor jogs and sends out noise.

Press STOP button twice. The motor jogs and sends out noise for 4 times.

Note: If you want to use the third limit, no matter where the blinds is, press and hold STOP button for 3 seconds.

7. Tilt function / dot movement

Press P2 button. The motor jogs and sends out noise.

Press UP button. The motor jogs and sends out noise.

Press DOWN button. The motor jogs and sends out noise.

8. Add new transmitters

Transmitter A:

Press P2 button on a matched transmitter A twice. The motor jogs and sends out noise.

Transmitter B:

Press P2 button on a new transmitter B. The motor jogs and sends out 7 times of noise.

Result: OK