Run Bison 6-Inch LED Disk Downlight: Use and Care Guide

Package Content

The package includes the following parts:

• Screws (A): 2
• Mounting bracket (C): 1
• Wire Nut (F): 3
• E26 Socket (B): 1
• Disk lamp (E): 1
• Mounting bracket (C): 1
• Spring Bracket (D): 2
• Screws (G): 2
• Connector (H): 1

Warranty

This product is warranted for 5 years from the date of purchase. For product issues, contact support@runbisonlighting.com for return and replacement. Liability for incidental or consequential damage is expressly excluded.

Safety Instructions

Please read and understand all instructions before operating or installing the product. Failure to do so may lead to electric shock, fire, or other injuries.

• Shut off the electricity to the wires you are working on.
• Do not open; no user-serviceable parts inside. Unauthorized modifications may void the warranty.
• WARNING: Risk of fire or electric shock. LED retrofit kit installation requires knowledge of luminaire electrical systems. Contact a qualified electrician if not qualified.
• Install this kit only in luminaires with the construction features shown in the photographs and/or drawings.
• Do not exceed the input rating of the luminaire.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• This device is not intended for use with emergency exits.
• This luminaire has not been modified to operate LED Lamp. Do not attempt to install or operate incandescent lamps or CFL in this luminaire.
• This retrofit kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by authorities having jurisdiction.

CAUTION: Connect fixture to a 120v / 60Hz power source. Any other connection voids the warranty.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

Surface Mount Installation

Option 1: Surface Mounting

Fig. 1: Use the provided screws (A) to install the mounting bracket (C) to the junction box.

Fig. 2: Use the provided wire nuts (F) to connect the light (E) and electrical wire.

Fig. 3: Use the toggle switch to select your desired lamp color temperature: Soft White (2700K), Warm White (3000K), Bright White (3500K), Cool White (4000K), or Daylight (5000K). Push all the wires and cables into the J-box. Snap the disk light into the mounting bracket (C) firmly.

Fig. 4: Make sure the disk light is secured to complete the installation.

Recessed Housing Installation

Option 2: Recessed Mount

Fig. 1: Use the provided screw (G) to mount the spring bracket (D) to mounting bracket (C).

Fig. 2: Plug the wire into the connector (H).

Fig. 3: Connect the two parts of connector (B & H) together.

Fig. 4: Mount the mounting bracket (C) on the disk light. Use the toggle switch to select your desired lamp color temperature: Soft White (2700K), Warm White (3000K), Bright White (3500K), Cool White (4000K), or Daylight (5000K).

Fig. 5: Thread the socket adapter (B) into the socket.

Fig. 6: Push all the wires into the housing. Snap the disk light into the housing firmly.

Fig. 7: Make sure the disk light is secured to complete the installation.

Dimmer Compatibility List