Simplifying embedded vision for all. - Arducam
User Guide for ArduCam models including: V1, Cable Extension Kit for Camera Module, V1 Cable Extension Kit for Camera Module
Arducam Sada prodlužovacího kabelu pro kameru Raspberry Pi
www.arducam.com Cable Extension Kit for Camera Module V1/V2/HQ/16MP-AF Getting Started IPublished in January 2022 by ARDUCAM TECHNOLOGY CO., LIMITED
File Info : application/pdf, 8 Pages, 1.59MB
DocumentDocumentwww.arducam.com
Cable Extension Kit
for Camera Module V1/V2/HQ/16MP-AF
Getting Started
I Published in January 2022 by ARDUCAM TECHNOLOGY CO., LIMITED
Things to Do Before Assembling the Cable Extension Kit
Note: To use the cable extension kit, you need to first follow the steps below to verify if the camera module you choose works properly.
Steps for The Official Camera Module V1.3N2.1/HQ
1. Connect the camera directly to your Raspberry Pi. 2. Open up a terminal, enter the following commands:
If you already got the latest Raspberry Pi OS and camera software: libcamera-still -t O If you are still using the legacy camera software: raspistill -t 0 If a live preview window pops up, you are good to go with the kit. If not, contact the company where you got your camera module for help.
Steps for The Arducam 16MP Autofocus Camera
A Before You Start
· Please make sure you are running the latest version of Raspberry Pi OS.(January 28th, 2022 or later releases, Debian version:11(Bullseye))
· For Bullseye users running on Pi O - 3, please also:
1. Open a terminal 2. Run sudo raspi-config 3. Navigate to Advanced Options 4. Enable Glamor graphic acceleration 5. Reboot your Pi
· For Raspberry Pi Compute Module 3/4
The latest software only supports one camera at this time. CM4 uses CAM1 by default.
1 Cable Extension Kit for Camera Module V1N2/HQ/16MP-AF