Instruction Manual for PUREMIC models including: Q1 Karaoke Machine Player Wireless, Q1, Karaoke Machine Player Wireless, Machine Player Wireless, Player Wireless, Wireless
Shanghai Loostone Information Technology Co., Ltd. K3AMC3 2A7ZR-K3AMC3 2A7ZRK3AMC3 k3amc3
FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement for receiver hub: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This station should be installed and operated with minimum distance 20cm between the radiator& your body.RF warning for microphone: The device has been evaluated to meet general RF exposure requirment. The wireless microphone can be used in portable exposure condition without restriction. Antenna Type:PCB Antenna Gain:-6.38dBi input impedance:50Ohm Prior to operation, when using the device in the 600 MHz guard bands and 600 MHz duplex gap, check and register in the appropriate white-space database to determine available channels. Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.Adobe PDF library 16.07 Adobe Illustrator(R) 24.0