Micro Switch V7-IB17D8-048-S Basic Switch
A Division of Honeywell Inc.
Freeport, Illinois, U.S.A.
Dimensional Drawing
Model Number: V7-IB17D8-048-S
Catalog Listing: V7-IBI7D8-048-S
Control Number: CW-84719
Drawing Number: MV7-IB17D8-048-S
Release Number: PR-17032
The drawing illustrates a basic switch with a rubber seal boot and a corrosion-resistant steel actuator. Key dimensions are provided:
- Rubber Seal Boot: .17 thickness
- Actuator length: .385 REF
- Actuator tip width: .187 ±.003
- Overall switch length: 2.340 ±.030
- Mounting hole diameter: .114 ±.002 DIA HOLE
- Lever position: .610 APPROX OPERATING POSITION .406 ±.003
- Lever dimensions: .114 ±.002, .126 ±.002 DIA, .875 ±.003, 1.135 ±.015
- Actuator tip to mounting hole center: .550 ±.020
- Mounting hole to end: .625 ±.015, .715 MAX
- Actuator width: .40
- Lever angle reference: .010 ±.030
- Lever angle reference: .020 ±.001(3)
- Lever width: .11
- Lever thickness: .040
- Lever angle reference: .32
- Lever angle reference: .10
Projection: Third angle projection is indicated.
Notes
1. CAUTION: OVERTRAVEL FORCE ON LEVER MUST NOT RESULT IN AN OVERTRAVEL FORCE ON PLUNGER EXCEEDING 5 POUNDS.
2. CHARACTERISTICS ARE APPROXIMATE WITHOUT RUBBER SEAL BOOT.
Characteristics
| Characteristic | Value |
|---|---|
| OPERATING FORCE | 50 GRAM (APPROX) |
Electrical Data
Contact Arrangement: SPDT
| Rating | Contact Arrangement |
|---|---|
| 11A 1/3 HP 125, 250, 277 VAC | S P D T |
| 1/2A 125 VDC, 1/4A 250 VDC | S P D T |
| 4A 125 VAC "L" | S P D T |
Model Designation: L156
Tolerances
Unless otherwise specified:
| Places | Tolerance |
|---|---|
| ONE PLACE | (.0) ±.030 |
| TWO PLACE | (.00) ±.015 |
| THREE PLACE | (.000) ±.005 |
| ANGLES | ± |
This drawing covers a proprietary item and is the property of Micro Switch, a division of Honeywell. This drawing is not to be copied or used without the approval of Micro Switch.
