User Manual for XENX models including: 2A3RB-SC, 2A3RB-BD01, SC-01, SC-01 Shortcuts Companion, Shortcuts Companion
Shenzhen ELET Technology Co., Ltd. SC Digital plate handle 2A3RB-SC 2A3RBSC sc
Shenzhen ELET Technology Co., Ltd. BD01 Bluetooth Dongle 2A3RB-BD01 2A3RBBD01 bd01
File Info : application/pdf, 3 Pages, 1.77MB
DocumentDocumentUser Manual download page www.xenx-tech.com/download Warranty information store.xenx-tech.com/warranty Should you have any question, please contact us support@xenx-tech.com www.xenx-tech.com ©2022 Xenx Technology Limited. All Right Reserved. Thank you for choosing XENX SC-01 Shortcuts Companion Package content Shortcuts Companion Bluetooth Dongle Quick Start Guide * AA size battery is not included 1 Install battery Open the battery cover on the back side of the controller. Install a standard AA size battery and close the battery cover. 2 Install driver Please download the install XENX Driver with the following link www.xenx-tech.com/download 3 Plug XENX Bluetooth dongle to the computer 4 Quick Shift Layouts: Normal QShift1 QShift1 QShift2 QShift2 QShift1+QShift2 Wheel Up PageUp Wheel Down PageDown Wheel Click Ctrl+0 Key 1 Key 2 Ctrl Shift Key 1 Ctrl Key 1 Ctrl Key 1 Ctrl Driver Interface Mode Selection Key Wheel Key 1 Key 2 Key 3 Key 4 Key 5 Quick Shift Key 1 Quick Shift Key 2 FCC Information and Copyright This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC RF warning statement: the device has been evaluated to meet general RF exposure requirement , The device can be used in portable exposure condition without restriction.