SGW1010 Evaluation Kit Quick Start Guide

SG Wireless

Introduction

This document provides a quick start guide for the SGW1010 Evaluation Kit. The SGW1010 Evaluation Board is pin and software compatible with the Nordic PCA10056 Kit, facilitating development with wireless modules.

The evaluation board features the SGW1010 module, various connectors, user interface elements like buttons and LEDs, and debugging interfaces.

Board Identification: The board is marked as "SGW1010-EVK VER. 0.00". It also displays FCC ID: 2AS9401 and IC: 25021-01.

Get Started

To begin using the SGW1010 Evaluation Kit, follow these steps:

Download and install the Segger J-Link software.
Download the Nordic nRF5 SDK v15 or newer.
Extract the SDK to a convenient working location.

Useful Links

SG Wireless SGW1010: www.sgwireless.com
Nordic nRF52840 Documentation: infocenter.nordicsemi.com
Nordic SDK Download: developer.nordicsemi.com
Nordic SDK Documentation: developer.nordicsemi.com/nRF5_SDK/doc/
Segger J-Link Download: www.segger.com/downloads/jlink/

Contact

For support, please email: evk.support@sgwireless.com

Pinout Guide

The SGW1010 Evaluation Board is pin and software compatible with the Nordic PCA10056 Kit.

General Purpose Input/Output (GPIO) Pins

The board provides access to numerous GPIO pins, many of which can also function as Analog-to-Digital Converter (ADC) inputs (AIN).

Header 1 (Left Side): P0.27, P0.26, P0.02/AIN0, P1.15, P1.14, P1.13, P1.12, P1.11, P1.10, P1.08, P1.07, P1.06, P1.05, P1.04, P1.03, P1.02, P1.01, P1.00

Header 2 (Right Side): P0.00, P0.01, P0.05, P0.06, P0.07, P0.08, P0.09, P0.10, P0.11, P0.13, P0.14, P0.15, P0.16, P0.17, P0.18, P0.19, P0.20, P0.21, P0.22, P0.23, P0.24, P0.25

Header 3 (Bottom): P0.03/AIN1, P0.04/AIN2, P0.28/AIN4, P0.29/AIN5, P0.30/AIN6, P0.31/AIN7

Connectors and Interfaces

The evaluation board includes several key connectors and interfaces:

USB1: Typically used for power and programming/debugging.
USB2: Often used for connecting peripherals or as a device interface.
LiPo Connector: For connecting a Lithium Polymer battery.
Power Input: Includes VIN (Voltage In), GND (Ground), EXT_VDD, EXT_VOUT pins for external power management.
Reset: A dedicated reset button and pin.
Power Switch: A slide switch labeled "POWER SW6" for turning the board on/off.
User Buttons: Four general-purpose buttons labeled SW1, SW2, SW3, SW4.
Status LEDs: Five LEDs labeled LED1 through LED5, indicating various states.
Debug In Header: For connecting external debug probes.
PROGRAM Header: For programming the module.

Caution

The SGW1010 Evaluation Board does not include LiPo cell protection or charging circuits. Only use LiPo cells/battery that feature both overcurrent and undervoltage protection.