SoClean Adapter for ResMed S9

Detach the injection fitting and short hose from the main SoClean hose. You will no longer need the injection fitting and short hose. Save these parts in case you need them in the future.

[Image: Diagram 1 showing the injection fitting and short hose detached from the main SoClean hose.]

Remove the original lid from your humidifier by opening the lid fully, grasping it near the hinges and pushing firmly away from the unit.

[Image: Diagram 2 showing the original humidifier lid being opened and detached.]

Remove the silicone gasket from the original lid and install it onto the new lid, making sure the gasket lies flat and fits over the two tabs. Install the new lid with the black injection hose by lining up the hinges and pulling firmly toward you until you hear a clicking in both hinges.

[Image: Diagram 3 showing the silicone gasket being transferred from the old lid to the new lid. Diagram 4 shows the new lid being attached to the humidifier.]

Add water to your reservoir, if needed. When closing the new lid, make sure that the hose on the underside passes into the reservoir opening and rests near the bottom.

[Image: Diagram 5 showing water in the reservoir and the hose correctly positioned.]

Attach the reservoir lid stem to the main tube connected to the check valve assembly.

[Image: Diagram 6 showing the reservoir lid stem connected to the main tube.]

To achieve the proper seal, firmly push down on the lid top until you hear a click. You are now ready to use the SoClean.

[Image: Diagram 6 showing the lid being pressed down to create a seal.]

Remove the main tube that is connected to the stem of the adapter by firmly pulling it off.

[Image: Diagram 1 showing the main tube being pulled off the adapter stem.]

Open the adapter lid fully.

[Image: Diagram 2 showing the adapter lid being opened.]

Remove the adapter lid by grasping it near the hinges and pushing firmly away from the unit.

[Image: Diagram 3 showing the adapter lid being removed from the unit.]

Remove the silicone gasket from the adapter lid and install it onto your original reservoir lid making sure the gasket lies flat and fits over the two tabs.

[Image: Diagram 4 showing the silicone gasket being transferred from the adapter lid to the original reservoir lid.]

Install your original reservoir lid by lining up the hinges and pulling firmly toward you until you hear a clicking in both hinges.

[Image: Diagram 5 showing the original reservoir lid being attached.]

Close your reservoir lid.

[Image: Diagram 6 showing the reservoir lid being closed.]