Instruction Manual for RONIS models including: Tronic Plus, Tronic Plus DOM Keypads, DOM Keypads, Keypads
RONIS Tronic Plus - Service And Support
RONIS Tronic Plus
Tronic Plus Assembly Drilling template ASSEMBLY Right hand door TRONIC+ : Drilling t 2,5 ø8,1 ø4,5 For housing the screw head TRONIC+ : Drilling template Left hand door 2,5 ø8,1 ø4,5 For housing the screw head Accessories ASSEMBLY C ø5x29.5 E ø3.5x9.5 F Strike plate D M3x18 Right door assembly ASSEMBLY A A A 18 mm x mm 1 2 18 + x mm Section A-A ø3.5 ø22 Right door assembly ASSEMBLY 3 4 Right door ! Warning: Connect blue part to the side of the legde 5 6 Right door Left door assembly ASSEMBLY A A B Section A-A 1 2 18 mm x mm B ø3.5 ø22 Left door assembly ASSEMBLY 3 Left door 5 4 ! Warning: Connect blue part to the side of the legde 6 Left door 1 Verify that the cable is properly Don't push any key during the wire connected (straight and untill assembly process. the bottom). 2 Relase the batteries thanks to T20 Torx Security screw located on the opposite of the battery case Verify that the batteries are in the right polarity (as indicated in the battery box). IMPORTANT The battery pack must remain connected during the release of the batteries. Otherwise, the internal clock will lose the time configuration. Important notes ASSEMBLY 3 Verify that the screws are not fastened too tight (<20kgf/cm2). 4 Verify that the latch works smoothly in and out, without any frinction with the door frame. LED lights ASSEMBLY After introducing the correct code and pressing ENTER, the three LEDs blink at the same time (green-yellow-red) and the lock does not work. Dead batteries: replace batteries. After pressing any button the yellow LED blinks. Dead or almost dead batteries: replace batteries. Batteries ASSEMBLY 1. Make sure the battery pack contains full powered batteries (don't screw the battery pack too tight to avoid breaking the mechanism) 2. If the lock is closed, introduce the user code (or the master one) to open it. 3. Replace the old batteries for new ones and disconnect the battery pack. Important We suggest to change once every three years the batteries for ensure their good condition. After a long time, the batteries can deteriorate and damage the lock, especially in hot environments Do not clean the locks with cleaning products with hydrochloric acid, lye or corrosive components, especially on the metallic parts.Adobe PDF Library 16.0.5 Adobe InDesign 17.1 (Macintosh)