Installation Guide for AUDAC models including: SSP500 2-Way Flush Mount Sauna Speaker, SSP500, 2-Way Flush Mount Sauna Speaker, Flush Mount Sauna Speaker, Mount Sauna Speaker, Sauna Speaker, Speaker

stijnv

download Product manual ( )

SSP500 - Flush mount 2-way sauna speaker 20W | AUDAC

Product manual ( )

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 5 Pages, 123.00KB

Document Document

Sauna Speaker SSP500
AUDAC
PROFESSIONAL AUDIO EQUIPMENT
2-Way Flush mount Sauna Speaker SSP500
Installation Guide

Installation Procedure
1) Cut a hole in the wall / ceiling on the desired mounting location of the loudspeaker with a diameter of 120 mm.
2) Take the loudspeaker, and remove the front grill. The front grill is attached to the loudspeakers basket by a simple clicking system, and can be easily removed by carefully clicking the front grill away from the loudspeaker's housing.
3) Provide the loudspeaker connection cable through the mounting hole. 4) Connect the loudspeaker to the output terminals of the amplifier.
Note
Notice the polarity markings when connecting the loudspeaker.
5) Place the loudspeaker on the desired mounting location, and put the loudspeaker's housing through the cut hole. Fasten the loudspeaker by putting four screws through the provided holes, and tighten them. Always use the proper fasteners, depending of the mounting surface.
Note
On the bottom side where the connection terminals of the loudspeaker are located, there's a gap provided in the loudspeaker housing and front grill. This gap is meant to let the moisture flow out of the loudspeaker. Always make sure this gap is mounted on the bottom side of the loudspeaker, when mounted in vertical position.
6) Once the mounting screws are tightened, the front grill can be assembled to the loudspeaker. This can be done by simply clicking the front grill to the loudspeaker's housing. Notice the front grill will only fit in one position, because of the gap to let the moisture flow out on the bottom side.
1

2

Specifications

Maximal Power RMS Power Impedance Sensitivity (1W / 1m) Max SPL Frequency response ( ± 3 dB) Drivers:
Dimensions Cut-out dimensions Built-in depth Weight Heat resistance Humidity resistance Ingress Protection

40 Watt 20 Watt 8 Ohm 86 dB 99 dB 75 Hz ­ 20 kHz 1" HF Coaxial 5" LF Ø 165 mm x 74 mm Ø 120 mm 60 mm 0.62 Kg up to 100°C 90 ~95% R.H. IP44

3

Ø158.3±0.1

Ø5.0 Ø140.2±0.1
Ø119.0±0.1 Ø91.8±0.1

11.0 Ø2.0
Ø10.0

4-Ø4.4

10

64.7±0.2

6.8 4.8

1.2

2.4

30.0

2.0 2.6

Ø126.4

8.0 1.8
3.4
Ø130.0

Ø157.2

36.5