Instruction Manual for streetwize models including: SWPB5 4 in 1 Jump Starter and Air Compressor, SWPB5, 4 in 1 Jump Starter and Air Compressor, Jump Starter and Air Compressor, Starter and Air Compressor, and Air Compressor, Air Compressor, Compressor

4 in 1 Jump Starter & Air Compressor

4 thg 6, 2024 — Intention for Use. Thank you for purchasing the Streetwize 4 in 1 Jump Starter. This manual outlines the functions, operations, and safety precautions of ...

[PDF] 4 in 1 Jump Starter & Air Compressor - Streetwize Accessories

This manual outlines the functions, operations, and safety ... When the jump starter and smart clip are properly connected, the smart jump adapter.


File Info : application/pdf, 10 Pages, 1.04MB

PDF preview unavailable. Download the PDF instead.

SWPB5 manual 2024
4 in 1 Jump Starter & Air Compressor SWPB5
Information For Use
10400 mAh Battery Capacity

Emergency Jumpstarts Petrol Engines: Up to 5000cc (5.0L)

Diesel Engines: Up to 3000cc (3.0L)

Manual Contents

Intention for Use

3

Contents

3

Charging the Unit

4

Performing Emergency Jump Starts

5

Air Compressor - Adapter Compatibility

6

Air Compressor - Control Panel

6

Air Compressor - How to Inflate

7

Air Compressor - Checking the Tyre Pressure

7

Air Compressor - Troubleshooting

7

LED Torch

7

Power Bank

8

Health & Safety Warnings

8

Technical Support

10

Technical Specifications

10

2

Intention for Use
Thank you for purchasing the Streetwize 4 in 1 Jump Starter. This manual outlines the functions, operations, and safety precautions of this product. Please read this manual carefully before use.
You can jump start a car, inflate bike tyres/basketballs, charge mobile phones, tablets and other electronics products. There is no need to worry about being stranded due to a bad car battery or flat tyre because the Streetwize 4 In 1 Super Jump Starter can solve all your problems. The product has a large-capacity lithium battery of 10,400 mAh to provide strong power. It provides 800A powerful jump starting, MAX 120PSI air compressing, and 100 Lumens lighting. The product is equipped with smart jumper cables with 10 protections, and it has a large digital display, which makes it very safe and easy to operate.

Contents
1. Streetwize 4 in 1 Jump Starter 2. Jump Start Cables/Adapter 3. Air Hose 4. Type-C USB cable 5. Mains Charger 6. Carry Case

6
4 in 1
Jump Starter & Air Compressor
Jump Starter I Air Compressor I Power Bank I LED Torch

1

2 5

3

4

3

JUMPSTART

Charging the Unit
1. Insert the Type-C charging cable into the Type-C input port on the jump starter panel. 2. Connect the other end of Type-C charging cable with the mains charger. 3. Plug the mains charger into an electrical socket, the product will start to charge, and
the battery indicator on the digital display will flash. When the 5 bars on the battery indicators are on consistently, it is fully charged. 4. When fully charged, remove the charging cable and mains charger.
4

OUTPUT

FLASHLIGHT

INPUT

OUTPUT

AIRHOLE

FLASHLIGHT

Performing Emergency Jump Starts
1. Before starting a car, turn on the jump starter and check whether the power compatibility is sufficient. 75% or more of battery power is recommended for starting a car.
2. Insert the smart jumper adapter into the 12V EC5 output port on the jump starter. When the jump starter and smart clip are properly connected, the smart jump adapter blinks green and red.
3. Clamp the red clip to the positive electrode of the battery, and the black clip to the negative electrode of the battery. When the smart jumper adapter shows a solid green light, it indicates that the jump starter is ready to jump start. Please start the car quickly; otherwise 90 seconds later, the red light on the smart jumper adapter will turn on, and in this case, you need to disconnect and reconnect in order to start.
4. Turn the car key or press the start button to start the car, after successful start please disconnect the jump starter from the car.
5. If the startup fails, remove the smart jumper adapter from the jump starter and repeat steps 1 to 4. However, it should be noted that in order to prevent the product from overheating, the interval between each start should be at least 60 seconds, and the number of consecutive starts should not exceed 3 times.
5

JUMPSTART

OUTPUT

INPUT

OUTPUT

AIRHOLE

Air Compressor - Adapter Compatibility
Air Chuck Cars, trucks,trailers, ATVs, motorcycle tyres & more.
Ball Adapter Basketballs, footballs, volleyballs etc.

Inflatable Adapter Pool tubes, floats, balloons, toys etc.
Bike Adapter Bicycle tyres.

Air Compressor - Control Panel
Press: Turn on, turn off, or stop pumping. Press and hold: To start inflating.
Press: To switch the inflation mode, you can successively switch car, motorcycle, bicycle, ball, personalized mode. Long press: To switch the pressure unit, you can switch PSI, Kpa, Bar.
Press: Reduce pressure, each short press can reduce 1PSI/10Kpa/0.1Bar. Long press: Continuously decrease the pressure setting value.
Press: Increase pressure, each short press can add 1PSI/10Kpa/0.1Bar. Long press: Continuously increase the pressure setting value.
Short press: Turn on the LED light. Press again to switch the lighting mode successively: ON, SOS, Strobe.

D E FA U LTS E T T I N G S

MODE

PSI

Car

36

Motorcycle

36

Bike

60

Ball

8

BAR 25 25 4.1 .5

6

Air Compressor - How to Inflate
1. Screw the end of the air hose into the threaded connection of the product's inflation port.
2. Connect the corresponding adapter and the targeted device to be inflated. 3. Input desired pressure then hold the "AIR" button. 4. The product will automatically stop inflating once the preset PSI/Kpa/BAR level has
been met. Please remove the air hose immediately after inflation is completed.
NOTE: When using the air compressor for extended period of time, it's recommended to allow the unit to cool for 10 minutes to prevent over-heating. Always refer to the manufacturer's recommended PSI/Kpa/BAR level for the item being inflated.

Air Compressor - Checking the Tyre Pressure
1. Screw the end of the air hose into the threaded connection of the product's inflation port. 2. With the lever open, connect the air chuck to the car's air valve. 3. Press the "AIR" key to power on. 4. Quickly close the lever to secure it on the car's air valve and avoid releasing air from the
tyre. The digital display will illuminate the current tyre pressure.

Air Compressor - Troubleshooting

Mode Meaning

E01

Battery overheat

E02

Motor overheat

E03

Air leakage

Fix
Turn off the unit, and allow 10 minutes to cool down.
Turn off the unit, and allow 10 minutes to cool down.
Disconnect and reconnect the air hose.

LED Torch
Press the LED button once to turn on the torch, and press again to switch the lighting modes: ON, SOS, Strobe. Regardless of the unit ON/OFF (Pressing AIR button), the torch is controlled independently by the LED button.
7

AIRHOLE

OUTPUT

INPUT

FLASHLIGHT

OUTPUT

JUMPSTART

Power Bank
1. Press"AIR"button to power on. 2. Connect a charging cable into a USB-A output port on the jump starter panel. 3. Insert the other end of the charging cable into a device to be charged, such as a mobile
phone or tablet. 4. Remove the charging cable from the product when not in use.
Phone, Tablet, Device.
Health & Safety Warnings
· The 4 in 1 jump starter & air compressor will generate heat when charging. Charge it in a well ventilated area. Keep away from heat sources, direct sunlight, humidity, water or other liquids.
· Do not operate the 4 in 1 jump starter & air compressor if it is wet or damaged to prevent electrical shock, explosion and/or injury. Improper repairs of this device may place the user at risk.
· Do not use with wet hands. Do not use this unit for anything other than its intended use.
· The 4 in 1 jump starter & air compressor is not a toy. Keep out of reach of children. · Do not charge under pillows, blankets or any other fabric. · Do not store in a car during hot weather. · Short-circuiting a Li-ion battery can cause it to ignite or explode. · DO NOT use or store at temperatures above 35°C or below 0°C.
8

· Never open a Li-ion battery's casing. Li ion batteries contain safety devices that protect the cells inside from abuse, if damaged these can cause the battery to ignite or explode
· Do not charge the 4 in 1 jump starter & air compressor and charge an electronic device at the same time. This will shorten the 4 in 1 jump starter & air compressor's battery life.
· Do not try to replace the battery.
· Do not shine the LED torch at your eyes as this may damage your sight.
· After startup, please pull out the connection from the smart clamp plug, do not pull out from the power cord.
· When the smart clip is inserted into jump starter, do not forcibly twist the smart clip to avoid damaging the internal electronic components.
· After using the air compressor allow to cool down before disassembling.
· Please use strictly in accordance with the standard inflation pressure of the charged tyre, ball or item.
· In order to ensure the longer service life of this product; it is recommended to let the power bank discharge (flatten), and recharge fully every three months. Do not store this product with a 0% charge, which may cause irreparable damage to the internal battery.

WEEE
GB

The WEEE symbol

on this product means that the 4 in 1 jump starter & air

compressor should be ethically dismantled or recycled to minimise environmental

impact. Please check with your local authority for more information.

FOR INDOOR USE ONLY
IMPORTANT: ADDITIONAL SAFETY INFORMATION
This 4 in 1 jump starter & air compressor is NOT intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised or have been given instruction concerning use of the 4 in 1 jump starter & air compressor by a person responsible for their safety.
9

Technical Support
If you require any technical support within the warranty period, please contact us on support@streetwize.co.uk and provide product name and supplier code (see Technical Specifications) along with the technical query and proof of purchase

Technical Specifications
Product
Supplier Code Battery Capacity Input USB Output Jump Starting Power
Operating Temp Cycle Life Weight Size Air Compressor

Streetwize 4 in 1 Jump Starter & Air Compressor
SWPB5 10,400mAh/38.48Wh Type-C 5V/2A 2x 5V 2.4A USB DC12V/200A(Start)~800A(Peak) Petrol: up to 5.0L/Diesel: up to 3.0L 32°F to 95°F/0°C to 35°C Approx. 1000 charges 750g L175mm x W106mm x H55mm Max Pressure: 120PSI Air Flow: 12L/min

Streetwize: Suite GA, Marsland House, Marsland Road, Sale M33 3AQ
www.streetwize.co.uk

For Product Support:
E: support@streetwize.co.uk T: +44 (0)161 447 8597

EU Regd Address:
Ace Supply Co (Europe) Ltd. Dublin 2 D02 A098 ROI



References

Adobe PDF Library 17.0 Adobe InDesign 19.1 (Macintosh)