Introduction
This manual describes how to replace the cabin filter. Before installing, please be sure to read this book to ensure safe and correct installation.
Estimated Installation Time: 5-10 minutes
In some cases, tools are required and replacement work adds additional time.
Recommended Replacement Time
1 year or 10,000km
However, it is recommended to check and replace your cabin filter as soon as possible when driving in heavily soiled areas.
The contents of this installation guide are accurate as of May 2022.
⚠️ Precautions for Installation and Use
- Be sure to park your vehicle in a safe place with the engine and air conditioner turned off before commencing the replacement process.
- When replacing your cabin filter, please refer to the instruction manual of the vehicle, maintenance manual, etc.
- This guide is just an example and may differ from the actual vehicle.
- Please refrain from unreasonable work. It may result in damaging the vehicle or personal injury.
- If you are not confident in the work, please consult your local workshop.
- Check the direction of the arrow so that you do not mistake the front and back of the filter when installing.
- This product displays AIR FLOW (wind direction) with an arrow, but other companies may display "TOP UP" on their filters.
H07 Cabin Filter Installation Guide
1. How to remove the glove box
For bolted glove boxes
Diagram description: A glove box assembly is shown with a damper and two bolts. The text instructs to remove the two bolts and then the damper.
- After removing the bolts (2 places), remove the damper.
- Remove the glove box.
For pinned glove boxes
Diagram description: A glove box assembly is shown with a damper and pins. A close-up view of a pin mechanism is provided. The text instructs to open the glove box, press the pins, remove the damper, and then the glove box.
- Open the glove box and press the pins (2 places) and take them out.
- Remove the damper.
- Remove the glove box.
2. Removing and installing the cabin filter
Diagram description: A cabin filter tray is shown with two knobs on the sides. The text instructs to hold the left and right knobs and pull the filter tray towards yourself to remove it.
- Hold the left and right knobs.
- Pull the cabin filter tray towards yourself to remove the tray.
3. How to install your Bosch cabin filter
Diagram description: A Bosch cabin filter is shown next to a filter tray. An arrow indicates the AIR FLOW direction. The text instructs to remove the old filter, insert the new Bosch cabin filter with the "AIR FLOW" arrows pointing down, and then restore the removed vehicle parts to their original positions.
In some cases, the filter tray has a cover. In this case, use a nipper or another tool to remove the layer before installing a new filter.
- Remove the old filter from the filter tray.
- Insert the Bosch cabin filter with the "AIR FLOW" arrows pointing down.
- Restore the removed vehicle parts to their original positions.
⚠️ Attention
- This work procedure is an example and may vary across different vehicles.
- Bosch's cabin filter indicates airflow with an arrow on the product. Please note that the arrow may indicate "TOP" on other genuine or IAM products.
- Please read the "Precautions for installation and use" on the installation guide cover before commencing.
- ? NOTE: Used cabin filters cannot be cleaned and reused.
Contact Information
Robert Bosch (Australia) Pty. Ltd.
1555 Centre Road
Clayton VIC 3168
For Further information please contact Bosch on:
Email: CustomerService.AA@au.bosch.com
Australia: 1300 307 040 www.boschaftermarket.com.au
New Zealand: 0800 452 896 www.boschaftermarket.co.nz
Invented for life | Bosch Global
Home | Bosch Mobility Aftermarket in Australia and New Zealand
Home | Bosch Mobility Aftermarket in Australia and New Zealand
