Sex Massager Manual: Features, Instructions, and Safety Information
Product Specification
A purple, curved sex massager with wavy textured surfaces, shown alongside a small white wireless remote control.
| Feature | Detail |
|---|---|
| Product Category | Female Masturbator |
| Product Function | 10 kinds Vibration / Sucking Lick |
| Wireless Remote | 10 m range |
| Material | Silicone + ABS |
| Rated Voltage | ≤ 3.7V |
| Battery Capacity | ≤ 300mAh |
| Charging Time | 90 minutes |
| Using Time | 90 minutes |
| Product Size | 105mm x 65mm x 40mm |
| Waterproof | Daily Waterproof |
Instructions
Functions and Controls
Diagram showing the massager's controls. A 'Rechargeable hole' is indicated. Text explains: 'long press to turn off.' and 'Short press to change mode (10 modes)'. Another instruction states: 'Press power switch key for 2 seconds can start vibration type, Short press to change mode (10 modes), long press to turn off.'
Charging Instruction
- Please charge fully for 2 hours before using for the first time.
- Please clean and dry before charging.
- Please connect USB cable to USB adapter (not included) to charge.
- Using time depends on the used speed. Power finishes faster at higher speeds.
- To extend the life of this product, we suggest you recharge when the indicator becomes weak on vibrating.
Warnings
- Carefully clean the toy before first use and after each use with warm water and a mild soap.
- Please use a few drops of water-based lubricant to ensure a pleasant feeling.
- Never use the product on a wound. If you feel uncomfortable while using it, please stop using it immediately and consult medical staff.
- Please do not use it while charging.
- Do not use cleanser with gasoline or acetone.
- Please store the toy between temperature 0℃-40℃, and do not expose the toy to direct sunlight.
- Keep the product in a dust-free area.
Maintenance
- Please clean well and keep it dry after using.
- Please keep it far away from children.
- Please keep it in a dry and cool place.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
