Owner's Manual for Porta Phone models including: B4HEVXT2-R, B4HEVXT2R, evxt2 r, EVXT2-R Full Duplex 2.4 GHz Transceiver Remote, EVXT2-R, Full Duplex 2.4 GHz Transceiver Remote, Duplex 2.4 GHz Transceiver Remote, 2.4 GHz Transceiver Remote, Transceiver Remote, Remote
Porta Phone Company Inc EVXT2-R Full Duplex 2.4 GHz Transceiver-Remote B4HEVXT2-R B4HEVXT2R evxt2 r
EVADE PRO USER MENU 1. Power ON/OFF Power ON: Press and hold the power button till to GREEN LED blinking or light up. Power OFF: Press and hold the power button till to the RED LED flashing. 2. Pairing(Register mode) a). Press and hold the power button to turn headset power ON, the power LED should blinking in Green color. b). Enter the pairing mode: Press the volume down button at 3 times continually, then press and hold the volume up till to the RED and Green LED blinking at alternately. c). Main unit enter the pairing mode first then also the Remote to pairing mode. d). The Green LED of Remote headset will several blink at fastly, then turn off after paired, press the power button to quit the pairing mode, keep the Main unit on the pairing mode then can pair with more Remote or press the power button to quit the pairing mode. e). Repeat the above step "d" for more Remote headset paired with the same Master, or press the power button to finish the pairing(register). (Note: . The Mani headset can accept maximum 15 remotes register in full duplex, or all the remotes fixed on listening mode, total register number over 250 headset available on listening mode. 3. Talking and listening a). The Main and Remote headset will start to search each other after power ON, the GREEN LED flash 1 time each 3 seconds. The headset will be link together automatically when the pairing ID confirmed by master and LED turn ON in GREEN color. b). Press the volume up and down button to adjust headset speaker sound volume. 4. Mic Muted Press the MUTE button on earcup tostop and activate Microphone function. FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. ISEDC Caution: This device complies with Innovation, Science, and Economic Development Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d' Innovation, Sciences et Développement écono mique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisé e aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le br ouillage est susceptible d'en compromettre le fonctionnement. Radiation Exposure Statement: The device has been tested and comply with FCC/ISED SAR limits. L'appareil a été testé et est conforme aux limites SAR de la FCC/ISED. To prevent possible hearing damage, do not listen at high volume levels for long periodsMicrosoft Office Word 2007 Microsoft Office Word 2007