Application Diagrams - Kramer ElectronicsVM-2H2
User Guide for KRAMER models including: VM-2H2, Distribution Amplifier
Go to www.kramerav.com/downloads/VM-2H2 to download the latest us
File Info : application/pdf, 2 Pages, 217.58KB
DocumentDocumentScan for full manual VM-2H2 Quick Start Guide This guide helps you install and use your VM-2H2 for the first time. Go to www.kramerav.com/downloads/VM-2H2 to download the latest user manual and check if firmware upgrades are available. Step 1: Check what's in the box VM-2H2 4K HDMI 2.0 1:2 DA 1 Power supply (5V DC) 4 Rubber feet 1 Quick start guide Step 2: Mount VM-2H2 Install VM-2H2 using one of the following methods: · Attach the rubber feet and place the unit on a flat surface. · Fasten a bracket on each side of the unit and attach it to a flat surface (see www.kramerav.com/downloads/VM-2H2). · Mount the unit in a rack using the recommended rack adapter (see www.kramerav.com/product/VM-2H2). · Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the device. · Avoid uneven mechanical loading. · Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of the circuits. · Reliable earthing of rack-mounted equipment should be maintained. · Maximum mounting height for the device is 2 meters. Step 3: Connect inputs and outputs Always switch OFF the power on each device before connecting it to your VM-2H2. To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-2H2. Using third-party cables may cause damage! VM-2H2 Quick Start P/N: 2 9 0 0 - 3 0 1 0 9 7 QS Rev: 3 Step 4: Connect power Connect the power cord to VM-2H2 and plug it into the mains electricity. Safety Instructions (See www.kramerav.com for updated safety information) Caution: · For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual. · There are no operator serviceable parts inside the unit. Warning: · Use only the power cord that is supplied with the unit. · Disconnect the power and unplug the unit from the wall before installing. Step 5: Set DIP-switches Set the DIP-switches according to your needs using the following table: DIP OFF (up) ON (down) Programming mode 1 Normal mode Enable programming HDCP Input (MAC mode) 2 HDCP enabled HDCP disabled Force RGB 3 Force RGB Normal mode Lock Default EDID 4 EDID not locked EDID locked