User Manual for bonondar models including: Z-Pi 800, Z-Pi 800 Z-Wave Plus Static Controller, Z-Wave Plus Static Controller, Static Controller, Controller
Manufacturer Manual
Z-Pi 800 User Manual FEATURES Z-Wave PlusTM Static Controller to easily add Z-WaveTM communication to your smart home ecosystem; Latest S2 security protocol for a truly private network; 800 Series Z-WaveTM Long Range for fast, low-power direct communication (For US Long Range frequency ONLY); Extended range up to a mile in open space when using Long Range; Designed for Raspberry Pi and Home Assistant Yellow hardware SPECIFICATIONS Model Number: Z-PI-V01 Power: 3.3 VDC SDK: 7.18.3 Operating Temperature: 32-104° F Operating Humidity: Up to 85% Installation and Use: Indoor only Dimensions: 50.4 x 19 x 7.4 mm. SET-UP Use this 800 Series Z-Wave PlusTM Pi Module as a wireless radio for your host controller, such as Raspberry Pi. Follow the detailed instructions in the link below to connect the module. Please proceed with caution when installing the device. Scan the code with your phone's camera and click on the link to access detailed installation instructions for the Z-Pi 800 module Once the controller is set up and connected to your home automation software, you can enjoy a fully secure, private Z-Wave PlusTM mesh network. If the software supports Z-WaveTM Long Range, enable direct communication between your devices and the controller for supreme range up to 1 mile and a larger network size up to 4000 nodes (For US Long Range frequency ONLY). Z-Pi GPIO MODULE AS SECONDARY CONTROLLER You can use the Pi module as a secondary controller to your current Z-WaveTM system if it accepts additional controllers. To enroll the module in your current system, send the inclusion command and put the module into learning mode using the SerialAPI mode in the interface. FAC TORY RESET The Pi Module can only be reset by the host software while it's in SerialAPI mode. The device is reset once an appropriate command from the host software is sent to reset the Z-WaveTM network. There is no way to manually reset the module without a connection to the host software. AWARNING This product should be installed indoors upon completion of any building renovations. Do not install the device in a place with direct sun exposure, high temperature, or humidity. Keep away from chemicals, water, and dust. Ensure the device is never close to any heat source or open flame to prevent fire. Ensure the device is connected to an electric power source that does not exceed the maximum load power. No part of the device may be replaced or repaired by the user. This product can pe included and operated in any Z-WaveTM network with other Z-WaveTM certified devices from other manufacturers and/or other applications. All non- battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. This product features the latest Security 2 (S2) framework to remove smart home network hacking risks. This ae vice is equipped with a unique authentication code for trusted wireless communication. WARRANTY This product is covered under a 12-month limited warranty.Microsoft Word 2019