USER MANUAL

01 Basic

This section details the components of the camera.

02 Basic Operations

Power On

After connecting with 5V power, the camera powers on automatically. The buzzer will beep once, and the blue and red LED lights will be always on. The camera is in standby mode at this time.

Mode Switch

After the camera is turned on, click the MODE button to switch between video mode and photo mode. The blue LED is on in video mode, and the green LED is on in photo mode.

Video and Photo

In video mode, click the SHUTTER/WIFI button to start recording. The buzzer will beep once, and the blue and red LED lights will flash. Click the SHUTTER/WIFI button again to stop recording. The buzzer will beep three times, and the blue and red LED lights will turn on.

In photo mode, click the SHUTTER/WIFI button to take a picture. The buzzer will sound once, and the green and red LED lights will be on.

Open WiFi

When the camera is in standby mode, long press the SHUTTER/WIFI button. The buzzer will beep for a long time, and the WiFi will be on. The camera's WiFi can be searched through the mobile phone. The WiFi name is FOXEER HS1223_XXXX, where XXXX is the last six digits of the camera's MAC address.

03 Setting Camera

Camera settings are managed through the FOXEER APP.

Video Mode

Video mode offers two capture modes: Video and Slow Motion.

Photo Mode

Photo mode offers two capture modes: Single and Auto.

Resolution

Photo Size

Quick Capture

Camera captures video automatically after powering on when QUIKCAP is enabled.

Looping Video

Available intervals for Looping are 2, 3, and 5 minutes. When Loop Recording is enabled, the recorded file is split into multiple sections written to the memory card. The camera continues recording until the memory card is full, and then overwrites the previous recorded content.

Auto Photo

Available intervals are 3, 5, 10, 30, and 60 seconds.

Light Frequency

Light Frequency can be configured to Auto, 50Hz, or 60Hz. Adjust the light frequency if you observe flashing on screen.

OSD

The OSD (on-screen display) setting determines whether to display the camera recording icon and parameter information. The options for this setting are On (default) and Off.

Beeps

You can turn on or turn off the beeps.

Video Timing Alarm

Your camera can be configured to start an alarm for 3, 5, or 10 minutes after recording. Beeps will last until you press any button.

Mic Volume

You can set the microphone volume to 100%, 90%, 80%, 70%, 60%, 50%, or Off.

White Balance

White balance allows you to adjust the color temperature of videos and photos to optimize for cool or warm lighting conditions.

ISO Limit

ISO Limit adjusts the camera's sensitivity in low-light environments, creating a balance between brightness and image noise. Image noise refers to the degree of graininess in the image. In low light, higher ISO values result in a brighter image but with greater image noise. Lower values result in lower image noise but darker images.

04 Connecting to the FOXEER App

The FOXEER App allows remote control of your camera using a smartphone or tablet. Features include full camera control, live preview, playback, and content sharing.

To Connect Your FOXEER BOX to the FOXEER App:

1. Download the FOXEER App to your smartphone/tablet from the Apple App Store or Google Play.
2. Follow the on-screen instructions to connect your camera to the app. The default password for your camera is 1234567890.

05 Customer Support

FOXEER is dedicated to providing the best possible service. To reach FOXEER Customer Support, visit www.foxeer.com.

06 Trademarks

FOXEER is a trademark or registered trademark of XAT in China and internationally. Other names and marks are the property of their respective owners.

[CE marking] [FCC logo]