Instruction Manual for VEVOR models including: T7 Rechargeable Desk Lamp, T7, Rechargeable Desk Lamp, Desk Lamp, Lamp
File Info : application/pdf, 8 Pages, 361.37KB
DocumentDocumentRECHARGEABLE DESK LAMP Technical Support and E-Warranty Certificate www.vevor.com/support MODEL:T7 RECHARGEABLE DESK LAMP This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product. -1- Symbol Symbol Description Warning: To reduce the risk of injury, the user must read the instructions manual carefully. This symbol, placed before a safety comment, indicates a kind of precaution, warning, or danger. Ignoring this warning may lead to an accident. To reduce the risk of injury, fire, or electrocution, please always follow the recommendation shown below. CORRECT DISPOSAL: This product is subject to the provision of European Directive 2012/ 19/EC. The symbol showing a wheelie bin crossed through indicates that the product requires separate refuse collection in the European Union. This applies to the product and all accessories marked with this symbol. Products marked as such may not be discarded with normal domestic waste, but must be taken to a collection point for recycling electrical and electronic devices. -2- FCC INFORMATION CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment! This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This product may cause harmful interference. 2)This product must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this product not expressly approved by the party.responsible for compliance could void the user's authority to operate the product. Note: This product has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception,which can be determined by turning the product off and on, the user is encouraged to try to correct the interference by one or more of the following measures. · Reorient or relocate the receiving antenna. · Increase the distance between the product and receiver. · Connect the product to an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for assistance. -3- Procedures of installation Operating Instructions Light Trigger: Touch the top of the lamp to switch the light While the lamp is on, press & hold the button to dim or brighten the light until -4- you reach your desired brightness level. Warning: This lamp is equipped with rechargeable lithium battery. The battery should not be exposed to heat and sunlight. Under no circumstances should the lamps be modified or stressed. Any change will lead to security and loyalty.The manufacturer is not responsible for any modified products Be Careful: Please carefully read the product use and maintenance instructions; Use according to the maintenance instructions to ensure the safety of the product. And keep the maintenance instructions properly.We will not assume any responsibility for the man-made damage caused by improper use,and all kinds of damages caused thereby are not covered by the warranty,and any changed products will not. Do not put the product into water or take it with wet hands.In case of any fault or damage, please stop using immediately and contact the local dealer or qualified technician.The rated input current is 100-240V~50/60Hz,and the rated output currentis5V DC (type-c)2A, The specified charger must be used Maintenance: If it is damaged, please select the cable with the same characteristics as the ariginal cable. Do not connect the power supply when cleaning the lamp. Remember to use soft cloth and neutral detergent or soap solution. Avoid using alcohol or detergent -5- containing acetone, thioberyllium, ammonia or any solvent. Avold mechanical pressure and heavy contamination.Prevent dust from entering-prevent water splashing.The replacement service of lamp source can only be provided by the manufacturer. Battery Charging: The USB cable is connected to the charging port of the lamp base,and the other end is connected to the power socket (5V adapter must be used). The red light indicates charging.and the green light indieates charging. Please charge continuously for more than 5 hours to ensure the best power. lt can be used continuously for about 6 hours after being fully charged. We recommend that the battery be fully charged and dischargedduring the first 10 times of use to ensure the best condition of the battery. Please charge as soon as possible when the battery is exhausted; The battery life will be shortened if there is no electricity for a long time. Battery replacement, Use original rechargeable batteries Under no circumstances should you use conventional batteries which may cause danger. If you need to replace batteries, please contact the manufacturer or dealer! Manufacturer: Shanghaimuxinmuyeyouxiangongsi Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN. EC REP: E-CrossStu GmbH. Mainzer Landstr.69, 60329 Frankfurt am Main. UK REP: YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122 Australia Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730 -6- Technical Support and E-Warranty Certificate www.vevor.com/support