CALDORAD - CALDORAD 9 TURBO TIMER

0 - WARNINGS

0.1 - General Information
Thank you for choosing our appliance.

0.2 - Symbols
Pictograms provide necessary information for correct, safe use.

0.3 - Editorial Pictograms

• Service ?️: Contact Customer Technical Service.
• Index ℹ️: Paragraphs with this symbol contain important safety information. Failure to comply may result in injury, warranty loss, or manufacturer liability refusal.
• Raised Hand ✋: Actions that must not be performed.
• HAZARD ⚠️: Indicates flammable refrigerant; risk of fire if leaked and exposed to ignition source.
• DANGER OF HIGH VOLTAGE ⚡: Risk of electric shock if safety rules are not followed.
• GENERIC DANGER ⚠️: Risk of physical damage if safety regulations are not followed.
• DANGER DUE TO HEAT ?: Risk of burns from contact with hot components.
• DO NOT COVER ?: Prohibits covering the appliance to prevent overheating.
• ATTENTION ?: Read this document carefully before installing/using. Assistance personnel must follow the installation manual. Additional information may be in attached manuals or user/installation manuals.

0.4 - General Warnings
When using electrical equipment, follow basic safety precautions to reduce risks of fire, electric shocks, and injury.

• Document is for restricted use; no copying or transfer without authorization. Appliances may change; manual text remains valid.
• Read manual carefully before any operation (installation, maintenance, use).
• Keep manual for future reference.
• Check appliance for damage after unpacking; keep packaging away from children.
• Manufacturer is not responsible for damages caused by failure to follow instructions.
• Manufacturer reserves the right to make model changes.
• Ensure mains data matches appliance data plate before connecting. Connect to single-phase AC power supply.
• Install according to manufacturer instructions; incorrect installation can cause damage.
• Use on a horizontal, stable surface or secure to wall.
• Always unreel the power cord completely during use.
• Replace damaged power cords only with manufacturer-approved parts or qualified personnel.
• Ensure controls are out of reach of persons using a bath or shower.
• Use extensions with caution.
• Keep air outlets at least 1m from flammable objects to avoid fire risk.
• Do not place near heat sources.
• Do not use to dry clothes.
• Do not insert foreign objects into vents (risk of shock, fire, damage).
• Avoid cord contact with hot surfaces.
• Route cord away from traffic areas to prevent tripping.
• Do not twist, kink, or wrap cord around the appliance.
• Do not store appliance while hot.
• Do not use outdoors or on wet surfaces; avoid liquid spills.
• Room floor area must be at least 5 m².
• Intended for floor use only; do not mount on ceiling.
• Do not operate near curtains (risk of material being sucked into vents).
• Keep packaging materials away from children.
• Forbidden for unsupervised children or disabled persons.
• Children over 8 and persons with reduced capacity may use under supervision/instruction.
• Children must not play with the appliance; user maintenance must be supervised.
• Keep children under 3 away unless continuously supervised.
• Children aged 3-8 may switch on/off with supervision/instruction.
• Children aged 3-8 must not plug in, regulate, or clean the appliance.
• Do not use near bath, shower, or swimming pool.
• Parts can become very hot and cause burns; exercise caution with children/vulnerable adults.
• Do not cover the appliance to avoid overheating.
• NEVER place under a mains socket, pull cord to unplug, expose to atmospheric agents, leave plugged in when not in use, or touch with wet hands.
• Use only as described; other uses may cause fire, electric shock, or injury.
• Overheating is often caused by dust/fluff; clean vents/grilles regularly.
• Do not use abrasive cleaners; clean with a damp cloth and mild detergent, then dry.
• Do not use chemically treated or antistatic cloths.
• Do not use petrol, solvents, polishing pastes, or similar products, as they can deform plastic surfaces.
• Do not use oils, chemical substances, or abrasive products.
• Do not wash or immerse the appliance in water.
• In case of malfunction, do not attempt disassembly; refer to retailer or technical assistance.
• Do not connect until fully assembled and adjusted.
• Use handles for moving.
• Do not immerse in water or other liquids.
• Do not operate in enclosed areas like cabinets (fire risk).
• If plug/socket is incompatible, have socket replaced by a qualified technician. Avoid adaptors/extensions if possible.
• Do not use if faulty, damaged, or dropped. Turn off, unplug, and have checked by qualified personnel.
• Unauthorized disassembly/repair voids warranty and can cause damage.
• Do not disassemble or modify the appliance.
• Self-repair is extremely dangerous.
• Do not use in small rooms with persons unable to leave autonomously without constant supervision.
• Do not unplug until the appliance is switched off.
• Check for damage after unpacking; contact authorized service if in doubt.
• Always disconnect from power supply when left unattended.
• To disable, cut the power supply cable and render hazardous parts harmless.
• First use or long inactivity may cause slight noise/odor (normal phenomenon).
• Appliance contains special oil; oil leaks require manufacturer repair.
• Follow regulations for oil disposal.

1 - Description of the Appliance and Commands

Appliance Components:

• 1. Appliance body
• 2. Radiator fin
• 3. Handle
• 4. Cable plate
• 5. Mode selection knob
• 5a. Mode switch
• 6. Power cord
• 7. Use and maintenance booklet
• 8. "U" bracket (2 pieces)
• 9. Wing nut (2 pieces)
• 10. Wheel (4 pieces)
• 11. Wheel support (2 pieces)
• 12. Indicator light for appliance operational
• 13. Room temperature adjustment knob
• 14. ON/OFF knob

2 - Installation

• After removing packaging, check appliance for damage. If in doubt, do not use and consult qualified personnel.
• Place appliance on a flat, stable surface, protecting the surface.
• Assemble wheels and supports: Insert brackets (8) into supports (11). Position supports (11, 11a) between outer radiator fins (2). For CALDORAD 7, secure supports (11b) with screws (9b). Rotate brackets (8) upwards. Lock supports (11) with wing nuts (9), do not overtighten. Rotate appliance to vertical position.
• Safety: Do not use without wheels/supports. Use only in vertical position (handle "3" up); other positions are dangerous.
• Ensure power cord is fully straightened.
• Place appliance in an appropriate environment on a stable, flat surface.
• Ensure curtains or other objects do not obstruct airflow (refer to fig. 3).
• Maintain at least 1m clearance on sides, behind, and above the appliance (refer to fig. 1).
• Ensure no flammable or heat-sensitive objects are within 1 meter of the appliance.
• Set knob (14) to "O" (OFF) and knob (13) to "MIN".
• Connect the plug to the power socket.
• Verify mains data matches the appliance data plate.
• Route the cord away from traffic areas to prevent tripping.

3 - Use

Knob "14" (ON/OFF):

• "O": Appliance OFF
• "ECO-MODULATING": Rotate knob to "ECO" position.
• "MEDIUM POWER": Rotate knob to " " position.
• "MAXIMUM POWER": Rotate knob to " " position.
• "TURBO": Rotate knob to " " position.

Knob "13" - Thermostat:

• Start the appliance by rotating knob (14) to the desired power; indicator (12) lights up.
• To set room temperature: rotate knob "13" clockwise to "MAX". Then, slowly rotate "13" counter-clockwise until the appliance switches off. The appliance will cycle on/off to maintain this temperature.

Knob "5" - Mode:

• Use switch (5a) to select one of three modes:
• Continuous mode "I": Selects room temperature.
• Timer mode " ": Sets a timer for appliance switch-off.
• Continuous mode "0": Switches off the appliance.

To completely switch off: Place knob (14) to "0"; LED (12) turns off. Disconnect the plug from the power socket.

4 - Operation

4.1 - "FAN" Mode
Select this mode by rotating knob (14) to the " " symbol.

4.2 - "TIMER" Mode
The appliance has a 24-hour interval timer with 96 segments (15 minutes each). Knob (5) is used for timer setting.

• Set Current Time: Rotate knob (5) clockwise, aligning the arrow with the current time.
• Set Timer Mode: Push segments outwards for the time the appliance should stay ON. Push segments inwards for the time the appliance should switch OFF. Example: To set ON at 05:00 and OFF at 06:00, push the 4 segments between 5 and 6 outwards.
• Set switch (5a) to " " to enable the timer. If switch (5a) is set to "I", the appliance operates in continuous mode, deactivating the timer.
• Timer settings are saved until the appliance is switched off. If unplugged, the current time is not automatically updated; reset it upon reconnection.

5 - Overheat Protection

The appliance has overheat protection that automatically switches it off. If this occurs:

• Unplug the appliance.
• Wait approximately 30 minutes for it to cool.
• Identify and remove the cause of overheating (e.g., something covering the appliance).
• Check the appliance, cord, and plug for damage.
• If no damage is found, plug in and switch on again. If it remains off, contact Customer Service.

6 - Safety Control (Tip Over Switch)

If the appliance falls or tilts, the tip-over switch automatically turns it off. It will restart normally when placed upright again.

7 - Maintenance and Cleaning

Before cleaning or maintenance: Unplug the appliance and wait for the fan to stop completely.

• Use a dry cloth for cleaning.
• For heavy dirt, use a damp cloth (not wet) with warm water (max 50°C) and mild detergent for external parts. Dry with a dry cloth.
• Use a brush or vacuum cleaner to remove dust from radiator fins (2).
• Ensure the appliance is completely dry before reconnecting the plug.
• Do not use chemically treated or antistatic cloths.
• Do not use petrol, solvents, polishing pastes, or similar products, as they may damage the plastic surface.
• Do not use oils, chemical substances, or abrasive products.
• Do not wash or immerse the appliance in water.
• In case of malfunction, do not attempt disassembly; refer to the retailer or technical assistance service.

8 - Preservation of the Appliance

For long periods of non-use or if performing dusty work:

• Switch off and unplug the appliance.
• Wrap the power cord (6) around the support (4).
• Store in a cool, dry place away from humidity.

9 - Technical Data

CALDORAD TIMER

CALDORAD 7/9/11

Contact Information:

Olimpia Splendid SpA
Via Industriale 1/3
25060 Cellatica (BS), Italy
www.olimpiasplendid.it
info@olimpiasplendid.it

Technical and aesthetic characteristics may change. Olimpia Splendid reserves the right to modify them at any time without prior notice.