Cecotec GrandHeat 2500 Flatbed Touch White Microwave Oven

1. Parts and Components

Refer to the diagrams for identification.

Figure 1: Microwave Overview

This diagram shows a side view of the microwave oven. Key components are labeled:

• 1. Control panel
• 2. Display
• 3. Door
• 4. Door handle

Figure 2: Control Panel Details

This diagram illustrates the buttons and controls on the control panel:

• 1. Automatic menus icons: Representing pre-set cooking programs for various food types (Pizza, Popcorn, Fish, Meat, Vegetables, Potato).
• 2. Time/weight knob: A rotary knob used for adjusting time and weight. It has a scale indicating minimum and maximum values.
• 3. Clock icon: Used for setting the time.
• 4. Defrost icon: Used for defrosting food.
• 5. Stop/Cancel icon: Used to pause or cancel cooking operations.
• 6. On/off icon: Used to start cooking or select power levels.
• 7. Reheat icon: Used for reheating food.
• 8. Start/+30s icon: Used to start cooking or add 30 seconds to the cooking time.

2. Before Use

Follow these steps before operating the microwave:

• Take the product out of the box.
• Remove any protective film.
• Check for damage and notify the Technical Support Service if found.
• Place the product on a flat, stable, and dry surface, away from corrosive materials, heat, and humidity.
• Ensure the power plug is accessible and the unit is effectively grounded to avoid electric shocks.
• The microwave door must be closed to operate.
• If there are manufacturing rests inside the cavity or on heating elements, leave the door open for ventilation and heat a glass of water at high power several times.

Warning: Do not remove the light brown mica cover attached to the microwave cavity, as it protects the magnetron.

3. Product Installation

Countertop Installation

• Place the appliance on a flat, stable surface.
• Minimum installation height: 85 mm.
• The rear surface should be placed against a wall.
• Maintain a minimum clearance of 30 cm above the microwave.
• Maintain a minimum clearance of 20 cm between the microwave and any adjacent walls.
• Do not remove the legs from the bottom of the microwave.
• Ensure intake and/or outlet openings are not blocked to prevent damage.
• Place the microwave as far away from radios and TVs as possible to avoid interference.
• Plug the device into a power supply.

Warning: Do not install the microwave over a range cooktop or other heat-producing appliance. Doing so could damage the unit and void the warranty.

4. Operation

Clock Settings

• When plugged in, the device will beep once.
• Tap the clock icon [clock-icon] to set the time. The hour digits will blink.
• Turn the knob to set the correct hour (00-23).
• Tap the clock icon [clock-icon] again. The minutes digits will blink.
• Turn the knob to set the correct minutes (00-59).
• Tap the clock icon [clock-icon] to save the time settings.

Note: If the clock is not set, the current time will not be displayed when the device is turned on.

During clock setting, tap the Stop/Clear icon [stop-cancel-icon] to go back to the previous status.

Timer

Turn the Time/weight knob [time-weight-knob] to increase or decrease the cooking time.

Note: If the clock has been set (24-hour system), the display will show the current time.

Pause or Cancel

During cooking, press the Stop/Cancel button [stop-cancel-icon] once to pause or twice to cancel the cooking process. During configuration, press the button to cancel settings.

Microwave Cooking

• Tap the On/off icon [on-off-icon] once. The screen will display "P100".
• Tap the On/off icon [on-off-icon] several times to select microwave power (P100 to P20).
• Tap the Start/+30s icon [start-plus-30s-icon] to confirm.
• Turn the knob to select the desired cooking time (0:05-60:00).
• Tap the Start/+30s icon [start-plus-30s-icon] to start cooking.

Microwave Power Chart

Weight Defrost

• Tap the Weight defrost icon [weight-defrost-icon]. The display will show "dEF1".
• Turn the knob to select the weight of the food (100-2000 g).
• Tap the Start/+30s icon [start-plus-30s-icon] to start the defrost process.

Time Defrost

• Tap the Time defrost icon [time-defrost-icon]. The display will show "dEF2".
• Turn the knob "+" or "-" to set the desired defrost time (maximum 60 minutes).
• Tap the Start/+30sec icon [start-plus-30s-icon] to start the defrost process.

Reheat

Press the Reheat button [reheat-icon]. The display will show weight options (e.g., 0.2 kg, 0.4 kg, 0.6 kg). Select the weight and press the start button to begin reheating.

Express Cooking

• In standby mode, tap the Start/+30s icon [start-plus-30s-icon] for 100% power for 30 seconds.
• Each subsequent touch increases the time by 30 seconds (maximum 60 minutes).
• Turn the time knob to select desired cooking time, then tap Start/+30s icon to start.

Note: This option is not available under Weight defrost or Auto menu cooking modes.

Multi-sequence Cooking

Up to 2 sequences can be set. If defrosting is included, it must be the first sequence. Auto menu and Express cooking cannot be part of multi-sequences.

Example: Defrost for 5 minutes, then cook at 80% power for 7 minutes.

• Tap Weight defrost icon [weight-defrost-icon] (display shows "dEF2").
• Turn knob to set 5 defrost minutes.
• Tap On/off icon [on-off-icon] twice for 80% power.
• Tap Start/+30s icon [start-plus-30s-icon] to confirm.
• Turn knob to set 7 minutes cooking time.
• Tap Start/+30s icon [start-plus-30s-icon] to start cooking.

Checking Settings

• During operation, tap On/off icon [on-off-icon] to view current power level (3 seconds).
• During operation, tap Clock icon [clock-icon] to view current time (3 seconds).

Child Lock System

In standby mode, hold down the Stop/Cancel icon [stop-cancel-icon] for 3 seconds to activate or deactivate the child lock. A long beep indicates activation/deactivation.

Auto Menu

• In standby mode, tap the corresponding icon to select an Auto menu function.
• Turn the knob to set the weight.
• Tap the Start/+30s icon [start-plus-30s-icon] to start cooking.

Menus:

The information above corresponds to food at 20 °C and 25 °C. Adjust time and temperature based on food temperature. For potatoes, covering with wrap is recommended. Food shape, weight, and temperature affect results. Follow auto menu conditions. Modify settings if results are unsatisfactory.

Auto Reminder

The device emits 3 beeps upon completion. If the door is not opened or "Stop/Cancel" is not pressed, it beeps every 3 minutes.

5. Cleaning and Maintenance

• Clean the device and food rests regularly.
• Unplug the power cord before cleaning.
• Do not immerse the product in water or any fluid.
• Lack of maintenance can cause deterioration and affect lifespan.
• Do not use strong detergents, powder abrasives, or metal brushes.
• Do not remove the mica plate.
• Strong odours may arise from prolonged use.

To Remove Odours:

• Place several lemon slices in a cup and heat at high power for 2-3 minutes.
• Place a cup of red tea inside and heat at high power for 2-3 minutes.
• Place orange peels inside and heat at high power for 1 minute.
• Use a dampened soft cloth to clean enclosures, door, interior walls, and door frame.

Warning: All maintenance tasks must be strictly carried out by qualified technical personnel.

6. Troubleshooting

7. Technical Specifications

• Model: 01675 GrandHeat 2500 Flatbed Touch White
• Rated input power: 1280 W
• Rated output power: 800 W
• Voltage/Frequency: 230V ~ 50 Hz
• Capacity: 25L
• Origin: Made in China | Designed in Spain

8. Disposal of Old Electrical Appliances

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE) mandates that old household electrical appliances must not be disposed of with normal municipal waste. Old appliances must be collected separately for optimal recovery and recycling, reducing environmental impact.

The crossed-out "wheeled bin" symbol ?️ on the product signifies your obligation to dispose of the appliance correctly.

Consumers should contact their local authorities or retailer for information on correct disposal of old appliances and batteries.

9. Technical Support and Warranty

This product is under warranty for 2 years from the date of purchase, provided proof of purchase is submitted, the product is in perfect physical condition, and it has been used properly as explained in this manual.

The warranty does not cover:

• Use for purposes other than intended, misuse, damage, exposure to moisture, immersion in liquids, or other customer-attributable faults.
• Disassembly, modification, or repair by unauthorized personnel.
• Faults due to normal wear and tear.

The warranty covers manufacturing defects for 2 years, except for consumable parts. Misuse will void the warranty.

For any problems or doubts, contact Cecotec Technical Support Service at +34 963 210 728.