Installation Guide for Olafus models including: 3-LBC60M Dual Lens Floodlight Camera, 3-LBC60M, Dual Lens Floodlight Camera, Lens Floodlight Camera, Floodlight Camera, Camera

APSBD0000443 M55 双目摄像头壁灯 说明书 Olafus 20240828 (安装操作说明书)打印档

User manual

Shen Zhen Shi Jiong Yu Ke Ji You Xian Gong Si 3-LBC60M 2BH66-3-LBC60M 2BH663LBC60M 3 lbc60m

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=7754263
Dual-Lens Floodlight Camera
Installation Instruction
MODEL: 3-LBC60M
PARTS LIST

Machine Screw QTY: 3

Expansion Rubber Plug QTY: 3

EVA Gasket QTY: 1

Mounting Bracket QTY: 1

Wire Nuts QTY: 3

F

Long Machine Screw QTY: 1

G

Silicone Gasket QTY: 1

H

Machine Screw QTY: 2

I

Machine Screw QTY: 2

J

Machine Screw QTY: 2

SPECIFICATIONS

Model Input Voltage Input Current Rated Power Luminous Flux
CCT CRI Power Factor L70B50 lifetime Beam Angle ta Luminaire Location

LED Floodlight 3-LBC60M
100-240Vj50/60Hz 0.6A 55W
5500lm 6500K
80 0.9 30000hours L70B50 @25° 120° -20-40°C/-4°F-104°F SUITABLE FOR WET LOCATIONS

4

SAFETY INFORMATION

WARNING
LIVE WIRES KEEP OUT

WARNING: Risk of electrical shock
Disconnect power at the fuse or circuit breaker before installing.
Verify that the supply voltage is correct. Connect fixture to a 100-240Vj50/60Hz power source.

Properly ground fixture.
Always follow code standards when installing wire connections. If you are outside of North America, installation and wiring must be performed by a licensed electrician.
CAUTION: Risk of fire
Do not install near combustible or flammable surfaces.
NOTICE
Do not connect this light fixture to a dimmer switch or timer. Floodlight Camera must be installed on a wall and on a UL listed junction box.
WARNING:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
DO NOT CONNECT THIS LIGHT FIXTURE TO AN UNGROUNDED ELECTRICAL SYSTEM. ATTACH GROUND FIXTURE WIRE TO EITHER GREEN GROUND SCREW ON MOUNTING PLATE OR THE GROUND WIRE IN THE OUTLET BOX.

2

SPECIFICATIONS

Video Field of View
Tracking Camera Angle
Audio Internet Requirements
Connectivity Storage

Camera 4MP 2160*1920P
110° wide & 95° Height viewing angle Auto Tracking & Human Detection Pan & Tilt340° horizontal and 110° vertical rotation range
Two-Way Talk with Audio and advanced noise cancellation. Recommended minimum upload speed of 2 Mbps per device.
802.11 b/g/n/ac Wi-Fi connection @2.4Hz 902-928 Mhz Radio
Micro SD Card up to 128GBcnot included

Model DimensionscLxHxW
Weight

DIMENSIONS
3-LBC60M 274 x 313 x 174mm/ 10.79 x 12.32 x 6.85 in
1.18kg/2.60 lb

H

L

W

5

COMPONENTS AND STRUCTURE
3-LBC60M

LED Light

Light Adjustment Knob USB interface

Lens 1
LED Indicator Lens 2

Camera Lock Collar
USB interface Reset Micro SD Card Slot

3
SHUT POWER OFF AT THE BREAKER
Turn off power to work area at main circuit breaker of fuse box Caution: Please make sure your wall switch and power at main circuit breaker both off.
If you don't know where your breaker is or how to turn off power to your floodlight circuit, consult with a licensed electrician.

PREPARATION
NOTE:
Before beginning assembly of product, make sure all parts are present. Compare parts with parts list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 30-60 minutes. Recommended to be installed 2.5m (8.2ft) above the ground but not higher than 5m (16.4ft). Product appearance may vary from image shown.
TOOLS REQUIREDcnot included

Flathead screwdriver

screwdriver

Silicone Sealant

Eye Protection

Pliers

Step Ladder

6

PROPER INSTALLATION HEIGHT
The proper installation height to optimize the motion sensor performance is around 2.5m (8.2ft)

2.5m(8.2ft)

Motion Detection Area UP to 5m(16.4ft)

1m(3.28ft)

7
RESTORE POWER AT THE BREAKER
After restoring power, the lights will turn on and your Floodlight Camera will begin speaking to you to let you know it's in setup mode.

10

INSTALLATION STEPS
FOR WET LOCATION, MAKE SURE FILL FULL THE GAP OF EVA GASKET AND MOUNTING SURFACE WITH SEALING COMPOUND OR SILICONE GLUE.

FG

D

H

F

Junction box(NOT INCLUDED)
NOK OK

RA

RE

Note

The raised part (RA) of the metal plate

must be engaged with the recessed part

(RE) of the base, otherwise it cannot be

installed.

E

WHITE NEUTRAL LINE FROM HOUSE
BLACK LIVE WIRE FROM HOUSE

WHITE NEUTRAL LINE FROM FIXTURE
BLACK LIVE WIRE FROM FIXTURE
8

FCC ID: 2BH66-3-LBC60M
FCC Warning:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

11

3
4
Note If the camera falls off accidentally, reinstall the camera as follows.
Counterclockwise tighten the screws
Rotate to the appropriate angle through the shaft
9
FAQ Find answers to your FAQs and more information here! Visit our website for assistance with questions about device connectivity issues, app operation problems, and much more.
https://olafuslife.com/paes/bc60m051us-faq-videos

Manufacturer/Hersteller: HK JW Illumination Co., Limited Address/Adresse: Unit 616, 6/f., Kam Teem Industrial Building, 135 Connaught Road West, Sai Wan Hong Kong Email: support@olafuslife.com
UK Importer: MDH LIGHTING LTD Address: 69 Aberdeen Avenue, Cambridge CB2 8DL, United Kingdom

EC

REP

MDH LIGHTING LTD Address/Adresse: Suite 302, 292 Strovolos Avenue, 2048 Strovolos Nicosia, Cyprus Email: service-MDHEU@hotmail.com

Made in China

www.olafuslife.com


Adobe PDF library 15.00 Adobe Illustrator(R) 24.0