Instruction Manual for MOSITOECO models including: 2AU7R-MST-F304A, 2AU7RMSTF304A, mst f304a, MST-F304A Remote Control, MST-F304A, Remote Control, Control, Remote
Huizhou MOSITOECO intelligence Lighting Technology Co., Ltd MST-F304A Remote control 2AU7R-MST-F304A 2AU7RMSTF304A mst f304a
MST-F304A Remote control operation instruction As shown in the figure: 1 button: to turn light ON or OFF 21 button: for fan LOW speed 30 buttonto turn fan OFF 42 buttonfor fan MEDIUM speed 53 buttonfor fan HIGH speed 6REDLED: Indicator light: When pressing the button, this light will light up and the remote control will send instructions. Restore electrical power.Within 30 seconds of restoring electrical power, press and hold the " 0 " button on the remote controtransmitterfor 5seconds or until ight on the fan blinkstwiceUsethe remote control transmitter to test the liaht and fan functions to confirm the learning process is complete. Tap button quickly to turn lights off or on. Hold button down to increase or decrease or decrease lights. If you press button in excess of 0.7seconds, it becomes a dimmer. The lights vary cyclically in 8 seconds. The light button has an auto resume function, which keeps the light at the same brightness as the last time it was turned off. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment The devices has been evaluated to meet general RF exposure requirement the device can be used in portable exposure condition without restrictionWPS 文字