kMeter II Installation Guide

Step 1

Flip the kBox over and remove the Snap-on Shaft Cover by hand.

[Image: Hands gripping and pulling a black plastic cover off a metal shaft.]

Step 2

Snap off the Battery Cover with a flat screwdriver.

Step 3

Slide in your new kMeter II so that the screws of the Chassis fit into the openings on the kMeter II's plastic base.

Note

Make sure the Sensor Disk is centered and as deep down as possible into the Reading Fork without touching the Reading Fork or the Circuit Board.

[Image: A close-up shows a rotating disk (Sensor Disk) positioned between two prongs (Reading Fork).]

Step 4

Secure the kMeter II in place by carefully tightening the M6 nuts with a 10mm wrench.

[Image: A hand is using a 10mm wrench to tighten a nut on a bolt, securing the kMeter II unit.]

Step 5

Snap the Battery Cover back on after installing the kMeter II.